Section R315-266-105 - Hazardous Waste Burned in Boilers and Industrial Furnaces - Standards to Control Particulate Matter(a) A boiler or industrial furnace burning hazardous waste may not emit particulate matter in excess of 180 milligrams per dry standard cubic meter, 0.08 grains per dry standard cubic foot, after correction to a stack gas concentration of 7% oxygen, using procedures prescribed in 40 CFR part 60, appendix A, methods 1 through 5, and appendix IX of Rule R315-266.(b) An owner or operator meeting the requirements of Subsection Rule R315-266-109(b) for the low risk waste exemption is exempt from the particulate matter standard.(c) Oxygen correction. (1) Measured pollutant levels shall be corrected for the amount of oxygen in the stack gas according to the formula: P c = P mx14/(E-Y)
Where:
P c is the corrected concentration of the pollutant in the stack gas, P m is the measured concentration of the pollutant in the stack gas, E is the oxygen concentration on a dry basis in the combustion air fed to the device, and Y is the measured oxygen concentration on a dry basis in the stack.
(2) For devices that feed normal combustion air, E will equal 21 percent. For devices that feed oxygen-enriched air for combustion, that is, air with an oxygen concentration exceeding 21 percent, the value of E will be the concentration of oxygen in the enriched air.(3) Compliance with all emission standards provided by Sections R315-266-100 through 112 shall be based on correcting to 7 percent oxygen using this procedure.(d) For the purposes of permit enforcement, compliance with the operating requirements specified in the permit, under Section R315-266-102, shall be regarded as compliance with Section R315-266-105. However, evidence that compliance with those permit conditions is insufficient to ensure compliance with the requirements of Section R315-266-105 may be "information" justifying modification or revocation and re-issuance of a permit under Section R315-270-41.Utah Admin. Code R315-266-105
Adopted by Utah State Bulletin Number 2016-9, effective 4/15/2016