Section 229.219 - Sanitary Operations(a) General maintenance. Buildings, fixtures, and other physical facilities of the plant must be maintained in a clean and sanitary condition and must be kept in repair to prevent food from becoming adulterated. Cleaning and sanitizing of utensils and equipment must be conducted in a manner that protects against allergen cross-contact and against contamination of food, food-contact surfaces, or food-packaging materials.(b) Substances used in cleaning and sanitizing; storage of toxic materials. (1) Cleaning compounds and sanitizing agents used in cleaning and sanitizing procedures must be free from undesirable microorganisms and must be safe and adequate under the conditions of use. Compliance with this requirement may be verified by any effective means including purchase of these substances under a supplier's guarantee or certification, or examination of these substances for contamination. Only the following toxic materials may be used or stored in a plant in areas where food is processed or exposed: (A) those required to maintain clean and sanitary conditions;(B) those necessary for use in laboratory testing procedures;(C) those necessary for plant and equipment maintenance and operation; and;(D) those necessary for use in the plant's operations.(2) Toxic cleaning compounds, sanitizing agents, and pesticide chemicals must be identified, held, and stored in a manner that protects against contamination of food, food-contact surfaces, or food-packaging materials.(c) Pest control. (1) All areas of the food plant must be kept free of rodents, insects, birds, and other pests which may contaminate food. Guard, guide, or pest detecting dogs may be allowed in some areas of a plant if the presence of the dogs is unlikely to result in contamination of food, food-contact surfaces, or food-packaging materials. Effective measures must be taken to exclude pests from the manufacturing, processing, packing, and holding areas and to protect against the contamination of food on the premises by pests. This exclusion of pests includes: (A) no evidence of pest activity in non-food areas;(B) no evidence of pest activity in food storage or food preparation areas; and;(C) no evidence of pest activity in or on food products, food packaging or food preparation utensils, equipment, or devices.(2) Only pesticides approved by the Environmental Protection Agency (EPA) for use in a food processing facility may be used. Pesticides must be used according to label directions. Rodenticides must be placed inside enclosed bait boxes or other approved receptacles. Only a licensed pesticide applicator may apply restricted use pesticides.(3) The use of pesticides is permitted only under precautions and restrictions that will protect against the contamination of food, food-contact surfaces, and food-packaging materials.(d) Sanitation of food-contact surfaces. All food-contact surfaces, including utensils and food-contact surfaces of equipment, must be cleaned as necessary to protect against allergen cross contact and against contamination of food. (1) Food-contact surfaces used for manufacturing/processing, packing, or holding low-moisture food must be in a clean, dry, sanitary condition before use. When the surfaces are wet-cleaned, they must, when necessary, be sanitized and thoroughly dried before subsequent use.(2) In wet processing, when cleaning is necessary to protect against allergen cross-contact or the introduction of microorganisms into food, all food-contact surfaces must be cleaned and sanitized before use and after any interruption during which the food-contact surfaces may have become contaminated. Where equipment and utensils are used in a continuous production operation, the utensils and food-contact surfaces of the equipment must be cleaned and sanitized as necessary.(3) Single-service articles (such as utensils intended for one-time use, paper cups, and paper towels) must be stored in appropriate containers and must be handled, dispensed, used, and disposed of in a manner that protects against allergen cross-contact and against contamination of food or food-contact surfaces.(e) Sanitation of non-food-contact surfaces. Non-food-contact surfaces of equipment used in the operation of a food plant must be cleaned in a manner and as frequently as necessary to protect against allergen cross-contact and against contamination of food, food-contact surfaces, and food-packaging materials.(f) Storage and handling of cleaned portable equipment and utensils. Cleaned and sanitized portable equipment with food-contact surfaces and utensils must be stored in a location and manner that protects food-contact surfaces from allergen cross-contact and from contamination.25 Tex. Admin. Code § 229.219
The provisions of this §229.219 adopted to be effective August 15, 1999, 24 TexReg 6082; amended to be effective March 19, 2001, 26 TexReg 2195; amended to be effective August 31, 2006, 31 TexReg 6746; Adopted by Texas Register, Volume 42, Number 30, July 28, 2017, TexReg 3791, eff. 8/2/2017