S.D. Admin. R. 74:52:02:11

Current through Register Vol. 51, page 54, October 28, 2024

Section 74:52:02:11 - Application requirements for manufacturing, commercial, mining, and silvicultural facilities which discharge only nonprocess wastewater

In addition to the information required by § 74:52:02:08, all manufacturing, commercial, mining, and silvicultural dischargers applying for SWD permits which discharge only nonprocess wastewater, excluding storm water, and not regulated by chapter 74:52:10, must provide the following information to the secretary, using application forms provided by the secretary:

(1) The location of the outfalls, including the latitude and longitude to the nearest 15 seconds and the name of the receiving water;

(2) The date of expected commencement of discharge;

(3) An identification of the general type of waste discharged, or expected to be discharged upon commencement of operations, including sanitary wastes, restaurant or cafeteria wastes, or noncontact cooling water. An identification of cooling water additives, if any, that are used or expected to be used upon commencement of operations, along with their composition if existing composition is available;

(4) Quantitative data for pollutants or parameters listed below, unless testing is waived by the secretary. The quantitative data may be data collected over the past 365 days, if they remain representative of current operations, and must include maximum daily value, average daily value, and the number of measurements taken. The applicant must collect as set forth in 40 C.F.R. 122.21 (g)(7) (July 24, 1992) and analyze samples in accordance with 40 C.F.R. Part 136 (July 1, 1996). New dischargers must include estimates for the pollutants and parameters listed below instead of actual sampling data, along with the source of each estimate. All levels must be reported or estimated as concentration and as total mass, except for flow, pH, and temperature:

(i) Biochemical oxygen demand (BOD);

(ii)Total suspended solids (TSS);

(iii) Fecal coliform, if believed to be present or if sanitary waste is or will be discharged;

(iv) Total residual chlorine, if chlorine is used;

(v) Oil and grease;

(vi) Chemical oxygen demand (COD), if noncontact cooling water is or will be discharged;

(vii) Total organic carbon (TOC), if noncontact cooling water is or will be discharged;

(viii) Ammonia (as N);

(ix) Discharge flow;

(x) pH; and

(xi) Temperature (both winter and summer).

S.D. Admin. R. 74:52:02:11

19 SDR 122, effective 2/21/1993; transferred from § 74:03:18:09.03, July 1, 1996; 23 SDR 180, effective 4/30/1997.

General Authority: SDCL 34A-2-30.

Law Implemented: SDCL 34A-2-40, 34A-2-44.