250 R.I. Code R. 250-RICR-120-05-39.10

Current through December 26, 2024

Section 250-RICR-120-05-39.10 - Inspection and Repair Requirements

A. The owner or operator of any HMIWI subject to the emission limits in §§ 39.9(A) and (B) of this Part must conduct an initial equipment inspection identifying any necessary repairs and yearly thereafter. All inspections must include the following:

1. Inspect all burners, pilot assemblies, and pilot sensing devices for proper operation; clean pilot flame sensor, as necessary;

2. Ensure proper adjustment of primary and secondary chamber combustion air, and adjust as necessary;

3. Inspect hinges and door latches, and lubricate as necessary;

4. Inspect dampers, fans, and blowers for proper operation;

5. Inspect HMIWI door and door gaskets for proper sealing;

6. Inspect motors for proper operation;

7. Inspect primary chamber refractory lining; clean and repair/replace lining as necessary;

8. Inspect incinerator shell for corrosion and/or hot spots;

9. Inspect secondary/tertiary chamber and stack and clean as necessary;

10. Inspect mechanical loader, including limit switches, for proper operation, if applicable;

11. Visually inspect waste bed (grates), and repair/seal, as appropriate;

12. For the burn cycle that follows the inspection, document that the incinerator is operating properly and make any necessary adjustments;

13. Inspect air pollution control device(s) for proper operation, if applicable;

14. Inspect waste heat boiler systems to ensure proper operation, if applicable;

15. Inspect bypass stack components;

16. Ensure proper calibration of thermocouples, sorbent feed systems and any other monitoring equipment; and

17. Generally observe that the equipment is maintained in good operating condition.

B. Any equipment deficiencies identified in the inspections as required in § 39.10(A) of this Part, or as a result of an equipment failure shall be completed within ten(10) days upon identification unless the owner or operator obtains written approval from the Department establishing an alternative date whereby all corrections of deficiencies shall be completed.

250 R.I. Code R. 250-RICR-120-05-39.10

Amended effective 12/26/2018