N.Y. Comp. Codes R. & Regs. Tit. 6 §§ 212-2.4

Current through Register Vol. 46, No. 51, December 18, 2024

Section 212-2.4 - Control of particulate emissions released from existing process emission sources

(a) Emissions from any process emission source f or which an application was received by the department prior to July 1, 1973 are restricted as follows:

(1) No facility owner or operator shall cause or allow emissions of particulate that exceed 0.15 grains per cubic foot of exhaust gas, expressed at standard conditions on a dry gas basis, except in instances where the determination of the permissible emission rate using process weight for a specific source category emitting solid particulate is based upon Table 5 and Table 6 of Subdivisions 212-2.5(a) and (b) of this Subpart.

(b) The control of particulate emissions released from new and modified process emission sources. Emissions from any process emission source for which an application was received by the department after July 1, 1973 are restricted as follows:

(1) No facility owner or operator shall cause or allow emissions of particulate that exceed 0.050 grains per cubic foot of exhaust gas, expressed at standard conditions on a dry gas basis, except in instances where determination of permissible emission rate using process weight for a specific source category emitting solid particulate is based upon Table 5 and Table 6 of Subdivisions 212-2.5(a) and (b) of this Subpart.

(c) Emissions of particulates shall be measured by using the emission testing method found in 40 CFR part 60 Appendix A-3 Method 5.

N.Y. Comp. Codes R. & Regs. Tit. 6 §§ 212-2.4

Adopted New York State Register June 3, 2015/Volume XXXVII, Issue 22, eff. 6/14/2015

Amended New York State Register February 10, 2021/Volume XLIII, Issue 06, eff. 2/24/2021