Statutes, codes, and regulations
New Jersey Administrative Code
Title 7 - ENVIRONMENTAL PROTECTIONChapter 14A - NEW JERSEY POLLUTANT DISCHARGE ELIMINATION SYSTEM
Subchapter 9 - GROUND WATER MONITORING REQUIREMENTS FOR SANITARY LANDFILLS
Section 7:14A-9.4 - General ground water monitoring well requirements

N.J. Admin. Code § 7:14A-9.4

Download
PDF
Current through Register Vol. 56, No. 23, December 2, 2024
Section 7:14A-9.4 - General ground water monitoring well requirements
(a) In addition to monitoring requirements specified elsewhere in this subchapter, the following requirements shall apply to installation, maintenance, sampling and closure of monitoring wells:
1. Ground water monitoring wells shall be constructed in accordance with the edition of the Department's "Field Sampling Procedures Manual" applicable at the time of well construction, an alternate method approved by the Department, or as set forth in the NJPDES-DGW permit.
2. A well permit, as required by N.J.S.A. 58:4A-1 et seq., shall be obtained prior to the installation of any ground water monitoring well. A clear and accurate record or base map providing any monitoring well location, depth, elevation and achievable pumping rate shall be kept at the facility by the owner or operator and be made available to the Department.
3. Ground water sampling shall be conducted in accordance with the edition of the Department's "Field Sampling Procedures Manual" applicable at the time of well sampling, an alternate method approved by the Department, or as set forth in the NJPDES-DGW permit.
4. Wells shall be capped to prevent precipitation from entering the well bore hole or introduction of extraneous material and substances into the well which might invalidate analytical results. All monitoring wells shall be cased in a manner that maintains the integrity of the monitoring well bore hole. Wells shall be screened and packed with gravel or sand where necessary to enable sample collection at depths where appropriate. The annular space (that is, the space between the bore hole and well casing) above the sampling depth shall be sealed with a suitable material (for example, cement grout or bentonite slurry) to prevent contamination of samples and ground water.
5. The elevation of the top of the well casing for each ground water monitoring well shall be established and said elevation shall be permanently marked on the well casing. The elevation established shall be in relation to the New Jersey Geodetic Control Survey datum. Each monitoring well casing shall be permanently marked with a number assigned or approved by the Department. This number will typically be the well permit number issued with the permit to construct the well.

N.J. Admin. Code § 7:14A-9.4