Section 445B.257 - Monitoring systems: Location1. All continuous monitoring systems or monitoring devices must be installed so that representative measurements of emissions or process parameters from the affected facility are obtained. Additional procedures for location of continuous monitoring systems are contained in the applicable Performance Specifications of Appendix B of 40 C.F.R. § 60.2. When the effluents from a single affected facility or two or more affected facilities subject to the same emission standards are combined before being released to the atmosphere, the owner or operator may install applicable continuous monitoring systems for each effluent or for the combined effluent. When the affected facilities are not subject to the same emission standards, separate continuous monitoring systems must be installed for each effluent. When the effluent from one affected facility is released to the atmosphere through more than one point, the owner or operator shall install applicable continuous monitoring systems on each separate effluent unless the installation of fewer systems is approved by the Director.Nev. Admin. Code § 445B.257
Environmental Comm'n, Air Quality Reg. §§ 2.17.6 & 2.17.7, eff. 12-4-76-Substituted in revision for NAC 445.684