Mo. Code Regs. tit. 10 § 10-6.030
Current through Register Vol. 49, No. 20, October 15, 2024
Section 10 CSR 10-6.030 - Sampling Methods for Air Pollution SourcesPURPOSE: This rule defines methods for performing emissions sampling on air pollution sources throughout Missouri when required in the Air Conservation Commission emission rules. The purpose of this rulemaking is to clean-up the incorporation by reference information in this rule to address the U.S. Environmental Protection Agency (EPA) concerns. The evidence supporting the need for this proposed rulemaking, per 536.016, RSMo, is an email dated September 18, 2018 from EPA.
PUBLISHER'S NOTE: The secretary of state has determined that the publication of the entire text of the material which is incorporated by reference as a portion of this rule would be unduly cumbersome or expensive. This material as incorporated by reference in this rule shall be maintained by the agency at its headquarters and shall be made available to the public for inspection and copying at no more than the actual cost of reproduction. This note applies only to the reference material. The entire text of the rule is printed here.
(1) Samples and velocity traverses for source sampling shall be conducted using Method 1 as specified by 40 CFR part 60, Appendix A in section (22) of this rule.(2) The velocity of stack gases shall be determined by measuring velocity head using a Type "S" (Stauscheibe or reverse type) pitot tube using Method 2 as specified by 40 CFR part 60, Appendix A in section (22) of this rule.(3) The carbon dioxide, oxygen, excess air, and dry molecular weight contained in stack gases shall be determined using Method 3 as specified by 40 CFR part 60, Appendix A in section (22) of this rule.(4) The moisture content in stack gases shall be determined using Method 4 as specified by 40 CFR part 60, Appendix A in section (22) of this rule.(5) Particulate Matter Emissions. (A) The concentration of particulate matter emissions in stack gases shall be determined using Method 5 as specified by 40 CFR part 60, Appendix A in section (22) of this rule.(B) The quantity of particulate matter emissions from certain industrial processes as determined by the director shall be determined using Method 17 as specified by 40 CFR part 60, Appendix A in section (22) of this rule.(C) The concentration of particulates of PM10 shall be determined using Method 201 as specified by 40 CFR part 51, Appendix M in section (21) of this rule. When water droplets are known to exist in emissions, use Method 5 as defined in subsection (5)(A) of this rule and consider the particulate catch to be PM10 emissions.(D) The concentration of particulates of PM10 shall be determined using Method 201A as specified by 40 CFR part 51, Appendix M in section (21) of this rule. When water droplets are known to exist in emissions, use Method 5 as defined in subsection (5)(A) of this rule and consider the particulate catch to be PM10 emissions.(E) The concentration of condensable particulate matter (CPM) emissions in stack gases shall be determined using Method 202 and Conditional Test Method 039 as specified by 40 CFR part 51, Appendix M in section (21) of this rule may be used to determine the total PM10 and PM2.5 fraction of filterable particulate matter including condensables.(F) The concentration of PM2.5 emissions in stack gases shall be determined using Method 202 and Conditional Test Method 040 as specified by 40 CFR part 51, Appendix M in section (21) of this rule. EPA Conditional Test Method 039 as specified in 40 CFR part 51, Appendix M in section (21) of this rule may be used to determine the total PM10 and PM2.5 fraction of filterable particulate matter including condens-ables.(6) The sulfur dioxide emissions from air pollution sources shall be determined using Method 6 as specified by 40 CFR part 60, Appendix A in section (22) of this rule.(7) The nitrogen oxide emissions from air pollution sources shall be determined using Method 7 as specified by 40 CFR part 60, Appendix A in section 22 of this rule.(8) The sulfuric acid mist and sulfur dioxide emissions from air pollution sources shall be determined using Method 8 as specified by 40 CFR part 60, Appendix A in section (22) of this rule.(9) Visible Emissions. (A) The visible emissions from air pollution sources shall be evaluated using Method 9 as specified by 40 CFR part 60, Appendix A in section (22) of this rule.(B) Visible fugitive emissions shall be evaluated using Method 22 as specified by 40 CFR part 60, Appendix A in section (22) of this rule.(10) The carbon monoxide emissions from air pollution sources shall be determined using Method 10 as specified by 40 CFR part 60, Appendix A in section (22) of this rule.(11) The hydrogen sulfide emissions from air pollution sources shall be determined using Method 11 as specified by 40 CFR part 60, Appendix A in section (22) of this rule.(12) The lead emissions from air pollution sources shall be determined using Method 12 as specified by 40 CFR part 60, Appendix A in section (22) of this rule.(13) The total fluoride emissions and the associated moisture content from air pollution sources shall be determined using Method 13A and 13B as specified by 40 CFR part 60, Appendix A in section (22) of this rule. For Method 13A or 13B, the sampling time for each run shall be at least sixty (60) minutes and the minimum sample volume shall be at least 0.85 standard dry cubic meter (thirty (30) standard dry cubic foot) except that shorter sampling times or smaller volumes, when necessitated by process variables or other factors, may be approved by the director.(14) Volatile organic compound emissions from air pollution sources shall be determined-(A) Using Method 25 as specified by 40 CFR part 60, Appendix A in section (22) of this rule;(B) Using Method 27 as specified by 40 CFR part 60, Appendix A in section (22) of this rule;(C) Using Method 24 as specified by 40 CFR part 60, Appendix A in section (22) of this rule;(D) Using Method 24A as specified by 40 CFR part 60, Appendix A in section (22) of this rule; or(E) Using Method 21 as specified by 40 CFR part 60, Appendix A in section (22) of this rule.(15) The hydrogen chloride emissions from air pollution sources shall be determined using Method 26 as specified by 40 CFR part 60, Appendix A in section (22) of this rule.(16) Dioxin and furan emissions from air pollution sources shall be determined using Method 23 as specified by 40 CFR part 60, Appendix A in section (22) of this rule.(17) The mercury emissions, both particulate and gaseous, from air pollution sources shall be determined using Method 101A as specified by 40 CFR part 61, Appendix B in section (23) of this rule.(18) The latest effective date of any 40 CFRpart 60, Appendix A-Test Methods shall beas designated in 10 CSR 10-6.070 NewSource Performance Regulations.(19) Alternative Sampling Method. An alter-native sampling method to any method refer-enced in this rule may be used provided it isin accordance with good professional prac-tice, provides results of at least the sameaccuracy and precision as the replacedmethod and receives the approval of thedirector for its use.(20) The capture efficiency of air pollution control devices shall be determined as specified by the U.S. Environmental Protection Agency's (EPA's) February 7, 1995 memorandum entitled, "Revised Capture Efficiency Guidance for Control of Volatile Organic Compound Emission" (GD 36) and the U.S. EPA's January 9, 1994 technical document entitled, "Guidelines for Determining Capture Efficiency." (GD 35) as published by EPA and hereby incorporated by reference in this rule. Copies can be obtained from the Office of Air Quality Planning and Standards, Leader, Measurement Technology Group, (Mail Code E143-02), Research Triangle Park, NC 27711. This rule does not incorporate any subsequent amendments or additions. For automobile and light-duty truck topcoat operations, the capture efficiency of air pollution control devices shall be determined as specified in U.S. E PA' s document entitled, "Protocol for Determining the Daily Volatile Organic Compound Emission Rate of Automobile and Light-Duty Truck Topcoat Operations" (US EPA-453/R-08-002), as published by EPA September 2008 and hereby incorporated by reference in this rule. Copies can be obtained from the National Technical Information Service (NTIS), 5285 Port Royal Road, Springfield VA 22161. This rule does not incorporate any subsequent amendments or additions.(21)40 CFR 51, Appendix M promulgated as of July 1, 2018 is hereby incorporated by reference in this rule, as published by the Office of the Federal Register. Copies can be obtained from the U.S. Publishing Office Bookstore, 710 N. Capitol Street N W, Washington DC 20401. This rule does not incorporate any subsequent amendments or additions.(22)40 CFR 60, Appendices A, B, and F promulgated as of July 1, 2018 are hereby incorporated by reference in this rule, as published by the Office of the Federal Register. Copies can be obtained from the U.S. Publishing Office Bookstore, 710 N. Capitol Street N W, Washington DC 20401. This rule does not incorporate any subsequent amendments or additions.(23)40 CFR 61, Appendix B promulgated as of July 1, 2018 is hereby incorporated by reference in this rule, as published by the Office of the Federal Register. Copies can be obtained from the U.S. Publishing Office Bookstore, 710 N. Capitol Street N W, Washington DC 20401. This rule does not incorporate any subsequent amendments or additions. AUTHORITY: sections 643.050, and 643.055, RSMo 2000.* Original rule filed Aug. 16, 1977, effective Feb. 11 , 1978. Amended: Filed Feb. 27, 1978, effective Dec. 11 , 1978. Amended: Filed Sept. 14, 1978, effective 4/12/1979. Amended: Filed July 16, 1979, effective Feb. 11 , 1980. Amended: Filed Dec. 10 , 1979, effective April 11 , 1980. Amended: Filed March 13, 1980, effective 9/12/1980. Amended: Filed Feb. 14, 1984, effective 7/12/1984. Amended: Filed June 2, 1987, effective 11/23/1987. Amended: Filed Sept. 1, 1987, effective 12/24/1987. Amended: Filed Aug. 4, 1988, effective 11/24/1988. Amended: Filed Feb. 4, 1991, effective 9/30/1991. Amended: Filed Sept. 3, 1991, effective 4/9/1992. Amended: Filed April 15, 1996, effective 11/30/1996. Amended: Filed April 14, 1998, effective 11/30/1998. Amended: Filed July 6, 2005, effective 2/28/2006. Amended by Missouri Register December 3, 2018/Volume 43, Number 23, effective 1/29/2019Amended by Missouri Register October 1, 2019/Volume 44, Number 19, effective 11/30/2019*Original authority: 643.050, RSMo 1965, amended 1972, 1992, 1993, 1995; and 643.055, RSMo 1979, amended 1992, 1994, transferred 1986, formerly 203.055.