Section 345 IAC 8-2-4 - Bulk milk collection; pickup tankers; samplesAuthority: IC 15-17-3-21; IC 15-18-1-14
Affected: IC 15-18-1-12
Sec. 4.
(a) Every bulk milk pickup tanker used to collect raw milk on a bulk milk route shall be of sanitary design and construction. The owner of a tank truck shall be responsible for maintaining it and its milk contact equipment in good repair. The bulk milk pickup tanker owner is responsible for cleaning and sanitizing the truck and equipment regularly in a manner and at a location approved by the board. A cleaning and sanitizing tag approved by the board shall be completed and affixed in the rear compartment of the bulk milk pickup tanker each day after cleaning and sanitizing. The bulk milk pickup tanker and its milk contact equipment shall be protected from contamination after being cleaned and sanitized.(b) Milk in a bulk milk pickup tanker shall be maintained at a temperature of forty-five (45) degrees Fahrenheit or less from the time of collection until delivered to a milk plant, receiving station, or transfer station. If the milk being delivered is manufacturing grade raw milk, the raw milk shall be maintained at a temperature of sixty (60) degrees Fahrenheit or less from the time of collection until delivered to a manufacturing grade milk plant, receiving station, or transfer station.(c) Tank trucks used to transport milk shall not be used to transport other products unless they have been thoroughly washed and sanitized after having been used to transport such other products. Only products fit for human consumption are authorized to be stored or transported in tank trucks used to transport milk or milk products.(d) The name and address of the owner of a bulk milk pickup tanker shall be legibly marked on both sides or on the rear of the vehicle. The name of the owner shall be in letters not less than three (3) inches in height provided that markings in use before March 1, 1998, may be the same height as the address, and the address shall be in letters not less than one and one-half (1 1/2) inches in height.(e) Every bulk milk pickup tanker used to collect raw milk on a bulk milk route shall be equipped with the following: (1) A sample dipper or other sampling device of sanitary construction approved by the board.(2) Sampling devices protected from contamination.(3) A sample carrying case constructed of such material and in such a way as to maintain producer raw milk samples at a temperature of thirty-two (32) to forty (40) degrees Fahrenheit from the time such samples are collected until they are delivered to the milk plant, receiving station, or transfer station.(4) A sample rack approved by the board and of sufficient size to hold at least one (1) sample of raw milk in an upright position from each bulk milk tank of each milk producer represented on the load of raw milk being transported to a milk plant, receiving station, or transfer station, plus one (1) sample to be used for temperature determination.(f) Each milk hauler shall be equipped with an accurate pocket-type thermometer with an unbreakable stem when collecting milk from dairy farms and shall observe the following sanitary practices in collecting milk: (1) The hauler's hands and outer clothing shall be clean during all pickup operations.(2) The milk shall be smelled through the port opening in the cover of the bulk tank for off-odors before raising the lid for a visual examination of the raw milk.(3) The hauler must visually examine the raw milk in the bulk tank. Milk that is visibly unfit for human consumption in accordance with the provisions of the Uniform Indiana Food, Drug, and Cosmetic Act shall be rejected and not collected. The lid shall be closed immediately after making the visual examination whenever possible.(4) The milk transfer hose used to withdraw raw milk from the farm bulk tank shall enter the milkhouse only through the port hole provided for that purpose.(5) Before connecting the transfer hose to the outlet port of the farm bulk tank, the outlet port shall be sanitized. If milk has leaked past the core of the outlet valve of the farm bulk tank, the outlet port of the valve shall be washed and sanitized before withdrawing the milk.(6) When the cap from the end of the transfer hose is being removed, it shall be handled in a sanitary manner and stored so as to prevent it from being contaminated while milk is being pumped from the farm bulk tank into the bulk milk pickup tanker.(7) After the milk has been removed from the farm bulk tank, the bottom of the tank shall be observed for sediment and milk abnormalities.(8) Conditions of abnormality or sediment shall be noted on the producer's copy of the weight ticket.(9) The: (A) date and time of milk collection;(B) temperature of the raw milk;(C) volume of milk collected;(D) grade of milk collected (Grade A or manufacturing grade);(E) milk hauler's signature; and(F) hauler's permit number; shall be legibly entered on the weight ticket.(10) After the milk has been removed from the farm bulk tank, the transfer hose shall be removed and recapped before the farm bulk tank is rinsed with water. After recapping, the transfer hose shall be rinsed free of exterior soil.(11) A milk hauler shall not collect milk from any dairy farm for delivery to a milk plant, receiving station, or transfer station for use in Grade A milk or milk products unless the farm holds a valid permit from the board authorizing the sale of Grade A raw milk for pasteurization.(12) At the time of collection of milk from each dairy farm, the milk hauler shall collect only that raw milk that has been stored continuously in the farm bulk tank from the time of milking until the time of milk collection. The milk hauler shall collect one (1) of the following:(A) The entire volume of milk stored in the farm bulk tank at the time of collection.(B) A portion of the volume of milk stored in the farm bulk tank at the time of collection may be collected only if an automatic recording chart is utilized with the tank. All precautions shall be taken to prevent the entrance of flies into the milkhouse.
(13) At least once each month, the milk hauler shall check the accuracy of the thermometer on each of his or her milk producer's bulk milk tanks against his or her pocket-type thermometer. The temperature obtained from both thermometers shall be entered on the weight ticket. If there is a difference between the readings on the two (2) thermometers, the reading of the bulk milk hauler's thermometer shall be reported as the official temperature on that day and on each succeeding day until the thermometer on the bulk milk tank is adjusted or repaired to be accurate.(g) Every time a milk hauler collects milk from a dairy farm, he or she shall collect a sample of milk from each farm bulk tank and silo after the milk has been thoroughly agitated and before opening the outlet valve. Samples may be collected from a properly installed and operated in-line-sampler or aseptic sampler that is approved by the board to collect representative samples. The sample shall be collected in the following manner:(1) If a sample dipper is used, the following apply: (A) The dipper shall be clean and transported between farms on the bulk milk route in a sanitizing solution equivalent to one hundred (100) parts per million chlorine. Other sampling devices shall be kept free of contamination.(B) After removal from the sanitizing solution, all of the sanitizing solution shall be drained from the sample dipper.(C) The sample dipper shall then be:(i) rinsed twice in the milk in the farm bulk tank; and(D) Samples must be taken through the port opening in the cover of the bulk tank.(2) A sample of not less than four (4) fluid ounces in volume or other sample sizes approved by the board shall be collected and placed in a sterile container.(3) The sample container shall be closed immediately after collection and immediately placed in melting ice water in the sample carrying case on the bulk milk pickup tanker in such a way that the top of the sample container is not submerged in the refrigerant. A sample carrying case may only be used to store samples of producer raw milk. Producer raw milk samples shall be maintained at a temperature of thirty-two (32) to forty (40) degrees Fahrenheit until delivered to the milk plant, receiving station, or transfer station. The samples shall not be frozen.(4) Each sample container shall be legibly marked with the following:(A) The date the sample was collected.(B) The temperature of the milk in the farm bulk tank.(C) The route and patron number of the milk producer.(D) The Indiana permit number of the dairy farm from which the sample was collected.(E) The permit number of the bulk milk hauler.(5) Before or at the time of collecting raw milk from the first milk producer on the bulk milk route, the milk hauler shall collect a sample of milk for temperature determination. The sample shall be refrigerated in the sample carrying case on the bulk milk pickup tanker until it arrives at the milk plant, receiving station, or transfer station.(6) Sampling equipment shall be rinsed in clean water immediately after each usage.(7) If one (1) pint samples are used to conduct sediment tests of each milk producer's raw milk, the milk hauler shall collect and legibly identify the full one (1) pint samples as requested by the milk plant, receiving station, transfer station, or board. A sample dipper of not less than one-half (1/2) pint capacity, which shall be cleaned and sanitized before the collection of each sample, shall be used. The one (1) pint samples shall be collected and transported in such a manner as to not interfere with the proper conduct of sediment tests.(h) Bulk milk tank raw milk shall be collected within the following time frames: (1) Manufacturing grade milk bulk tank raw milk shall be collected at least one (1) time every seventy-two (72) hours.(2) Manufacturing grade raw milk shipped in cans shall be collected at least one (1) time every forty-eight (48) hours.(3) Grade A bulk tank raw milk shall be collected at least one (1) time every forty-eight (48) hours.(4) Grade A and manufacturing grade goat milk shall be collected at least one (1) time every seven (7) days.(5) In the case of an emergency, the state veterinarian or the state veterinarian's designee may permit milk to be collected after the time frames otherwise specified in this subsection. Bulk milk tank raw milk that is not collected within these time frames may not be collected and used for Grade A or manufacturing grade milk or milk products.
(i) It shall be the responsibility of the milk plant, receiving station, or transfer station to: (1) provide competent personnel to receive producer raw milk samples from each bulk milk pickup tanker;(2) ascertain and record the temperature of the temperature sample;(3) see that the samples are properly identified and stored before delivery to the laboratory; and(4) provide facilities for the storage of producer raw milk samples at a temperature of thirty-two (32) to forty (40) degrees Fahrenheit at which temperature they shall be maintained until they are received by an official or officially designated laboratory for analysis. Producer raw milk samples shall not be frozen, and samples to be used for bacteriological determinations shall not be transferred to another sample container after they have been collected by the milk hauler except under conditions and by personnel approved by the board. Required laboratory analysis should begin within sixty (60) hours after the time of sample collection. Results of the analysis on the milk of Grade A producers shall be submitted to the board on forms and in a manner approved by the board. Milk producers and milk haulers shall not receive notice of which samples are to be used for bacteriological analysis.
(j) Any truck transporting raw, heat-treated, or pasteurized milk and milk products to a milk plant from another milk plant, receiving station, or transfer station must meet the identification and shipping requirements in IC 15-18-1-12. A shipping manifest must also indicate the bulk tank unit or units or plant identification number.Indiana State Board of Animal Health; HDP 86 Rule 13, Sec 4; filed Apr 26, 1979, 12:00 p.m.: 2 IR 696, eff one hundred twenty (120) days after filing with secretary of state; filed Apr 17, 1998, 9:00 a.m.: 21 IR 3349; errata filed Aug 13, 1998, 1:13 p.m.: 22 IR 125; errata filed Aug 13, 1998, 1:16 p.m.: 22 IR 126; readopted filed May 2, 2001, 1:45 p.m.: 24 IR 2895; filed Sep 27, 2002, 2:40 p.m.: 26 IR 338; filed Jul 18, 2005, 1:00 p.m.: 28 IR 3562; readopted filed May 9, 2007, 3:16 p.m.: 20070516-IR-345070037RFA; errata filed Oct 3, 2008, 3:30 p.m.: 20081022-IR-345080767ACA; filed Sep 11, 2012, 2:35 p.m.: 20121010-IR-345120107FRA) NOTE: Transferred from the Indiana State Department of Health ( 410 IAC 8-13-4) to the Indiana State Board of Animal Health ( 345 IAC 8-2-4) by P.L. 138-1996, SECTION 76, effective July 1, 1996.Filed 12/4/2014, 1:59 p.m.: 20141224-IR-345140199FRAFiled 12/7/2016, 9:26 a.m.: 20170104-IR-345160222FRAReadopted filed 7/12/2022, 2:33 p.m.: 20220810-IR-345220146RFA Transferred from the Indiana State Department of Health (410 IAC 8-13-4) to the Indiana State Board of Animal Health (345 IAC 8-2-4) by P.L. 137-1996, SECTION 76, effective July 1, 1996.