Ariz. Admin. Code § 11-1-1108

Current through Register Vol. 30, No. 24, June 14, 2024

Section R11-1-1108 - Use of Hoisting Rope, Tail Rope, Guide or Rubbing Rope on Friction Hoist

A. No hoisting rope on a friction hoist shall be used in a shaft or winze of a mine where, in any part of the rope:

1. The existing strength has decreased to less than 90% of the original strength of the rope.

2. The extension of a test piece has decreased to less than 60% of its original extension when tested to destruction.

3. The number of broken wires in any section of the rope equalling the length of one lay of the rope exceeds six.

4. Marked corrosion occurs.

5. The rate of stretch in a friction hoisting rope begins to show a rapid increase over the normal stretch noted during its service.

B. No tail rope, guide or rubbing rope shall be used in shaft where, in any part of the rope:

1. The existing strength has decreased to less than 75% of the original strength of the rope.

2. The extension of a test piece has decreased to less than 60% of its original extension when tested to destruction.

3. The number of broken wires in any section of the rope equalling the length of one lay exceeds six.

4. Marked corrosion occurs.

Ariz. Admin. Code § R11-1-1108

Adopted effective April 7, 1976 (Supp. 76-2).