Section 4.1-32-04 - Unloading chutes and vehicles used by rendering plant - Regulations governing1. Any unloading places or chutes used by a rendering plant or establishment must be on cement floors that can be cleaned and disinfected. Every vehicle used for transporting carcasses of dead animals to a rendering plant or establishment must:a. Have a bed or tank not less than fifty inches [127 centimeters] in width which is all metal, metal lined, or watertight for at least six inches [15.24 centimeters] above the floor of the box or bed of the vehicle.b. Have a metal-lined endgate that is hinged at the bottom of the bed or box of the vehicle and is fastened firmly to the top of the bed or box of the vehicle when closed.c. Have sides, a top, and an endgate that will prevent flies and other insects from entering the vehicle.d. Carry a tank filled with a solution approved by the state veterinarian for use as a disinfectant.e. Be disinfected with the solution described in subdivision d after it has been used for collecting a dead animal and before it enters upon any public highway of this state. Special attention must be given to all those parts of the vehicle which came in contact with the ground while upon the premises.f. Be thoroughly washed and disinfected with the solution described in subdivision d or with live steam, or both, after the dead animal has been unloaded at the rendering plant.2. The operator of any vehicle used for transporting the carcasses of dead animals to a rendering plant shall wash with disinfectant, paying special attention to disinfecting the operator's hands and footwear, with the solution described in subdivision d of subsection 1 immediately after leaving any farm at which the operator has collected the carcass of a dead animal.Added by S.L. 2017, ch. 68 (SB 2028),§ 6, eff. 7/1/2017.