Section 42291 - Material used in plastic trash bags recycled plastic postconsumer material(a) Until January 1, 1998, every manufacturer that manufactures plastic trash bags of 0.75 mil or greater thickness for sale in this state shall ensure that at least 30 percent of the material used in those plastic trash bags is recycled plastic postconsumer material.(b)(1) On and after January 1, 1998, the manufacturer's required use of recycled plastic postconsumer material shall be determined pursuant to paragraph (2). Compliance by a manufacturer with either alternative shall be deemed to be compliance with this subdivision.(2) Every manufacturer of regulated bags shall do one of the following: (A) Ensure that its plastic trash bags intended for sale in this state contain a quantity of recycled plastic postconsumer material equal to at least 10 percent of the weight of the regulated bags.(B) Ensure that at least 30 percent of the weight of the material used in all of its plastic products intended for sale in this state is recycled plastic postconsumer material.(3) Beginning March 1, 1999, and annually thereafter, every manufacturer subject to this subdivision shall certify to the board that it has used the required amount of recycled plastic postconsumer material annually in compliance with paragraph (2).(c) Any certification of postconsumer materials used for compliance with this chapter shall not include any materials that are certified or used for compliance with any other state or federal requirement that requires the use or reporting of postconsumer materials for any plastic products.(d) If any manufacturer subject to this section is unable to obtain sufficient amounts of recycled plastic postconsumer material to comply with this section within a reporting period because of unavailability or because the available material did not meet recycled plastic postconsumer material quality standards adopted by the board, the manufacturer shall certify that fact to the board. Each manufacturer making that certification shall make a reasonable effort to identify available supplies of material before submitting certification to the board.(e) The Legislature hereby finds and declares that although the changes made to this section by the act amending this section during the 1998 portion of the 1997-98 Regular Session become effective after January 1, 1998, it is the intent of the Legislature that the new requirements specified in subdivision (b) be effective as of January 1, 1998. The Legislature further finds that this change is requested by the manufacturers subject to this section and that the retroactive effect of these changes will not cause any hardship on any manufacturer subject to this section, or cause any manufacturer to be subject to regulatory action as a result of these changes, but rather, would instead have the effect of preventing hardship to the manufacturers regulated by this section.Ca. Pub. Res. Code § 42291
Amended by Stats. 1998, Ch. 44, Sec. 3. Effective May 22, 1998.