Statutes, codes, and regulations
Wisconsin Administrative Code
Agency - Department of Safety and Professional ServicesSafety, Buildings, and EnvironmentGeneral, Part IChapter SPS 302 - Fee Schedule
Subchapter VI - Building Water Systems
Section SPS 302.64 - Plumbing systems

Wis. Admin. Code Department of Safety and Professional Services SPS 302.64

Download
PDF
Current through November 25, 2024
Section SPS 302.64 - Plumbing systems
(1) GENERAL. Plan examination fees for preliminary or complete plans shall accompany the plans and specifications when submitted. If the department determines, upon review of the plans, that inadequate fees were provided, the necessary additional fees shall be provided prior to departmental approval.
(2) EXAMINATION FEES. The plan examination fee shall be determined in accordance with Table 302.64-1. The minimum fee shall be $85.00 per plan.

Table 302.64-1

Plan Examination Fees for Plumbing Systems

Plan TypeFee
1. Sanitary drain and vent system ................... $50.00 per inch diameter of each bldg. sewer, or for multiple sewer connections serving a single building the fee may be calculated per sub. (3) (a)
2. Sanitary building sewer only, no drain and vent ...... $30.00 per inch diameter of each bldg. sewer
3. Building water distribution system ................ $50.00 per inch diameter of each water service, or for multiple water service connections serving a single building the fee may be calculated per sub. (3) (b)
4. Building water service only, no water distribution system ......................................... $30.00 per inch diameter of each water service
*5. Car wash interceptor ........................... $85.00 per interceptor
*6. Clearwater drain system ......................... $15.00 per inch diameter of each clearwater drain system
*7.Garage catch basin ............................. $85.00 per basin
*8. Grease interceptor ............................. $85.00 per interceptor
*9. Oil interceptor ................................ $85.00 per interceptor
*10. Sanitary dump station .......................... $85.00 per station
*11. Chemical waste system ......................... $85.00 per system
13. Alternate plumbing system ...................... $800.00 per system
14. Manufactured home communities and campground/ recreational vehicle parks:
. a. 1-25 sites ................................... $300.00
b. 26-50 sites ................................... $350.00
c. 51-125 sites.................................. $400.00
d. over 125 sites ................................ $500.00
15. Private water main ............................. $30.00 per inch diameter
16. Cross connection control assemblies:
a. Reduced pressure principle backflow preventer ...... $170.00 per assembly
b. Reduced pressure fire protection principle backflow preventer .................................... $170.00 per assembly
c. Pressure vacuum breaker assembly ................ $170.00 per assembly
d. Spill resistant vacuum breaker .................... $170.00 per assembly
e. Reduced pressure detector fire protection backflow preventer .................................... $170.00 per assembly
17. Sanitary private interceptor main sewers, determined on the largest diameter of each interceptor main sewer . . . $30.00 per inch diameter
18. Stormwater systems:
a. Less than or equal to one acre drainage area ......... $15.00 per inch of largest diameter storm sewer, or for multiple sewer discharge points for a single site the fee may be calculated per sub. (3) (c)
b. [GREATER THAN] one or equal to 5 acres drainage area............. $350.00
c. [GREATER THAN] 5 acres to [LESS THAN] or equal to 15 acres drainage area...... $500.00
d. [GREATER THAN] 15 acres drainage area ......................... $600.00
19. Experimental plumbing system ................... $1,000.00 per system
20. Water or wastewater treatment systems, other than PoWTS, designed to achieve compliance with Table 382.70-1 ..................................... Amount as specified in s. SPS 302.04(1)
21. Stormwater and clearwater infiltration systems for public buildings or facilities ......................... $200.00 per system**

* For table entries 5. to 11., no additional fee would be required if submitted with the respective drain and vent system.

** This fee is in addition to building stormwater and clearwater plumbing systems.

(3) EXAMINATION FEES FOR ADDITIONS AND REMODELING. When new or relocated fixtures or both are connected to the existing piping inside a building, the fee shall be determined in accordance with the following procedures:
(a)Sanitary building sewer, drain and vent.
1. Total all of the drainage fixture units which are being added or relocated.
2. Refer to s. SPS 382.30 Table 382.30-2, and determine the horizontal drain size which would be required if all new or relocated fixtures discharged through one pipe.

Note: Disregard the asterisk limitation regarding water closets. This pipe size is used for determining the fee only and does not necessarily mean this pipe size is used in actual design or installation.

3. Determine the fee based on pipe diameter in Table 302.64-1, line 1.
(b)Building water distribution system.
1. Total all of the water supply fixture units which are being added or relocated, using s. SPS 382.40 Tables 382.40-1 and 2, and convert to gallons per minute (GPM) in accordance with s. SPS 382.40 Table 382.40-3.
2. The fees shall be determined in accordance with GPM demand of the new or relocated fixtures as specified in Table 302.64-2.

Table 302.64-2

Plan Examination Fees for Building Water Distribution Systems

GPMFee
1. 1-6.................................... $25.00
2. 7-12 .................................. $35.00
3. 13-21 ................................. $50.00
4. 22-31 ................................. $60.00
5. 32-46 ................................. $75.00
6. 47-77 ................................. $100.00
7. 78-119 .............................. $125.00
8. 120-170 ................................ $150.00
9. 171-298 ............................... $175.00

(c)Building storm sewer and drainage system.
1. Total each different type of area which the new or relocated drains serve and convert to GPM using ch. SPS 382 Tables 382.36 -1, 2 and 3. To this, add the GPM discharge from any added or relocated clear water drains located inside the building.
2. Refer to ch. SPS 382 Table 382.36-4, using the column for 1/4 inch per foot pitch, to determine the horizontal drain size which would be required if all new or relocated fixtures discharged through one pipe. Use this pipe size for determining the fee.
3. Determine the fee based on pipe diameter in Table 302.64-1, line 18. a.

Wis. Admin. Code Department of Safety and Professional Services SPS 302.64

Cr. Register, June, 1992, No. 438, eff. 7-1-92; am. Table 2.64-1, Register, February, 1994, No. 458, eff. 3-1-94; am. Table 2.64-1; Register, February, 1997, No. 494, eff. 3-1-97; am. (3) (a) 3. and (c) 3. and Tables 2.64 -1 and 2.64-2, Register, July, 2000, No. 535, eff. 9-1-00; CR 02-002: am. Table 2.64-1 Register April 2003 No. 568, eff. 5-1-03; CR 04-035: am Table 2.64-1 Register November 2004 No. 587, eff. 12-1-04; CR 08-039: am. (2), (3) (a) 3., (c) 3. and Tables 2.64 -1 and 2.64-2 Register November 2008 No. 635, eff. 12-1-08; CR 09-050: am. Table 2.64-1 Register December 2009 No. 648, eff. 1-1-10; correction in (3) (a) 2., 3., (b) 1., 2., (c) 1., 2., 3., Table 302.64-1 made under s. 13.92(4) (b) 7, Stats., Register December 2011 No. 672.