Wis. Admin. Code Department of Natural Resources NR 815.07

Current through September 30, 2024
Section NR 815.07 - Approval of injection wells
(1) A regulatory agency may not approve the construction or use of a class I, II or III injection well.
(2) Subject to the limitation contained in sub. (4), the department may only approve the construction or use of a class IV injection well, if the well is to be used to reinject treated contaminated groundwater back into the formation from which the groundwater was withdrawn and is approved by the department as part of a remedial action necessary for the cleanup of soil or groundwater contamination.
(3) Subject to the limitation contained in sub. (4), a regulatory agency may approve a class V injection well as specified in subch. IV.
(4) A regulatory agency may not approve the construction or use of any injection well that would violate the provisions of ch. 160, Stats., result in the endangerment of an underground source of drinking water or otherwise fail to comply with the other applicable requirements of this chapter.

Note: Section 160.19(4), Stats., prohibits a state regulatory agency from promulgating a rule defining design and management practice criteria that permits a preventive action limit to be attained or exceeded in groundwater except as allowed under s. 160.19(2), Stats. A state regulatory agency may not promulgate a rule defining design and management practice criteria that permits an enforcement standard to be attained or exceeded at the point of standards application.

Note: Endangerment, as it applies to Class V injection wells that are not prohibited under subchapter III, is any exceedance of an enforcement standard established under ch. 160, Stats., when measured at a point of standards application as defined in s. 160.01(5), Stats.

(5) Failure to comply with any condition of an injection well approval voids the approval.

Wis. Admin. Code Department of Natural Resources NR 815.07

CR 01-104: cr. Register October 2004 No. 586, eff. 11-1-04.