Section NR 670.310 - What equipment information shall I keep at my facility?If your facility has equipment to which subch. BB of ch. NR 664 applies, keep the following information at your facility:
(1) For each piece of equipment to which subch. BB of ch. NR 664 applies:(a) Equipment identification number and hazardous waste management unit identification.(b) Approximate locations within the facility (for example, identify the hazardous waste management unit on a facility plot plan).(c) Type of equipment (for example, a pump or a pipeline valve).(d) Percent by weight of total organics in the hazardous waste stream at the equipment.(e) Hazardous waste state at the equipment (for example, gas, vapor, or liquid).(f) Method of compliance with the standard (for example, monthly leak detection and repair or equipped with dual mechanical seals).(2) For facilities that cannot install a closed-vent system and control device to comply with subch. BB of ch. NR 664 on the effective date that the facility becomes subject to the subch. BB of ch. NR 664 provisions, an implementation schedule as specified in s. NR 664.1033(1) (b).(3) Documentation that demonstrates compliance with the equipment standards in ss. NR 6264.1052 and 664.1059. This documentation shall contain the records required under s. NR 664.1064.(4) Documentation to demonstrate compliance with s. NR 664.1060 shall include the following information: (a) A list of all information references and sources used in preparing the documentation.(b) Records, including the dates, of each compliance test required by s. NR 664.1033(10).(c) A design analysis, specifications, drawings, schematics and piping and instrumentation diagrams based on the appropriate sections of "Course 415: Control of Gaseous Emissions," incorporated by reference in s. NR 660.11, or other engineering texts acceptable to the department that present basic control device design information. The design analysis shall address the vent stream characteristics and control device operation parameters as specified in s. NR 664.1035(2) (d) 3.(d) A statement signed and dated by the owner or operator certifying that the operating parameters used in the design analysis reasonably represent the conditions that exist when the hazardous waste management unit is operating at the highest load or capacity level reasonable expected to occur.(e) A statement signed and dated by the owner or operator certifying that the control device is designed to operate at an efficiency of 95 weight percent or greater.Wis. Admin. Code Department of Natural Resources NR 670.310
Adopted by, CR 16-007: cr. Register July 2017 No. 739, eff.8/1/2017