Current through Register Vol. XLI, No. 45, November 8, 2024
Section 47-60-6 - Monitoring Well Location And Reporting Requirements6.1. Where prior groundwater regulatory agency approval is required, monitoring wells shall be installed at the locations indicated on the approved plans and specifications.6.2. Following installation of a monitoring well, each certified monitoring well driller shall report to the Secretary, on forms provided by the Secretary, the following information within sixty (60) days after completion of the well installation. 6.2.a. The name and address of the person for whom the wells were installed;6.2.b. The date the wells were installed; and6.2.c. The latitude and longitude coordinates in degrees, minutes, and seconds to the nearest second, and the method used to determine such coordinates for each well installed.6.3. The certified monitoring well driller shall assign each monitoring well a registration number using the following system: 6.3.a. The first group of numbers will be the certified monitoring well driller's certification number followed by a dash (-).6.3.b. The second group of numbers will represent the number of the monitoring well(s) installed by the driller for the calendar year followed by a dash (-).6.3.c. The third group of numbers will represent the calendar year in which the well was installed. Example: The first well drilled by a certified monitoring well driller with certification number 0123 in calendar year 1996 would be: 0123-0001-96.6.4. The certified monitoring well driller shall permanently affix the registration number onto each well installed.6.5. Failure to comply with any part of section 6 of this rule may result in enforcement action taken pursuant to 47CSR59 §7.