Section 296-155-33915 - Compression hardware(1) You must follow these assembly requirements for wire rope clips: (a) Before installing a wire rope clip on plastic coated or plastic impregnated wire rope, the wire rope clip manufacturer, you must consult the wire rope manufacturer or a qualified person . (b) For U-bolt clips used to create end terminations, you must place the saddle on the live end of the wire rope, with the U-bolt on the dead end side. (See Figure 24, Wire Rope Clips.)(c) You must test the assembly by loading the connection to at least the expected working load. After unloading, retighten the wire rope clips to the torque recommended by the manufacturer or a qualified person. (d) You must follow the manufacturer's recommendations for the minimum number of clips, spacing and turnback measurements, and to the recommended torque values. In the absence of the manufacturer's recommendations follow Table 5. Click here to view image
Figure 24 Wire Rope Clips
(2)Wedge sockets. You must follow these assembly requirements for wedge sockets: (a) Wedge sockets must be assembled as recommended by the manufacturer or a qualified person.(b) Before installing a wedge socket on plastic coated or plastic impregnated wire rope the wedge socket manufacturer, you must consult the wire rope manufacturer or a qualified person.(c) The assembler must match the proper wedge with the socket for the wire rope to be installed. Wedges must not be interchanged between different manufacturers' sockets or models.(d) The live end of the wire rope in the wedge socket cavity must be in alignment with the socket's pin. (See Figure 25, Wedge Sockets.)(e) The length of the dead end tail of the wire rope must be as required by the manufacturer or a qualified person.(f) The tail of the dead end of the wire rope extending beyond the wedge socket must be secured as recommended by the wedge socket manufacturer or a qualified person.(g) The dead end of the wire rope must not be secured to the live end of the wire rope in a way that restricts the movement of the live end. (See Figure 25.)(h) After assembly the connection must be loaded to fully seat the wedge before use. Click here to view image
Figure 25 Wedge Sockets
Wash. Admin. Code § 296-155-33915
Amended by WSR 16-09-085, Filed 4/19/2016, effective 5/20/2016Statutory Authority: RCW 49.17.010, 49.17.040, 49.17.050, 49.17.060 and chapter 49.17 RCW, and 29 C.F.R. 1926, Subpart CC. 13-02-068, § 296-155-33915, filed 12/31/12, effective 2/1/13.