Section 246-236-061 - Inspection and maintenance(1) The licensee shall perform inspection and maintenance checks that include, as a minimum, each of the following at the frequency specified in the license or license application: (a) Operability of each aspect of the access control system required under WAC 246-236-023;(b) Functioning of the source position indicator required under WAC 246-236-031(2);(c) Operability of the radiation monitor for radioactive contamination in pool water required under WAC 246-236-059(2) using a radiation check source, if applicable;(d) Operability of the over-pool radiation monitor at underwater irradiators as required under WAC 246-236-029(2);(e) Operability of the product exit monitor required under WAC 246-236-029(1);(f) Operability of the emergency source return control required under WAC 246-236-031(3);(g) Leak-tightness of systems through which pool water circulates (visual inspection);(h) Operability of the heat and smoke detectors and extinguisher system required under WAC 246-236-027 (but without turning extinguishers on);(i) Operability of the means of pool water replenishment required under WAC 246-236-033(3);(j) Operability of the indicators of high and low pool water levels required under WAC 246-236-033(4);(k) Operability of the intrusion alarm required under WAC 246-236-023(9), if applicable; (l) Functioning and wear of the system, mechanisms, and cables used to raise and lower sources;(m) Condition of the barrier to prevent products from hitting the sources or source mechanism as required under WAC 246-236-035;(n) Amount of water added to the pool to determine if the pool is leaking;(o) Electrical wiring on required safety systems for radiation damage;(p) Pool water conductivity measurements and analysis as required under WAC 246-236-063(2).(2) Malfunctions and defects found during inspection and maintenance checks must be repaired without undue delay.Wash. Admin. Code § 246-236-061
Adopted by WSR 18-15-017, Filed 7/9/2018, effective 8/9/2018