9 Va. Admin. Code § 5-40-4040
Current through Register Vol. 41, No. 6, November 4, 2024
Section 9VAC5-40-4040 - Control technology guidelinesA. Sheet basecoat (exterior and interior) and overvarnish; two-piece can exterior (basecoat and overvarnish). The control technology should consist of one or more of the following: 1. Use of electrodeposited waterborne coatings;2. Use of ultraviolet coatings;3. Use of high solids coatings;4. Carbon adsorption; and6. Any technology of equal or greater control efficiency when compared to the use of coating complying with 9VAC5-40-4030 A 1, provided such technology is approved by the board.B. Two-piece and three-piece can interior body spray; two-piece can exterior end (spray or roll coat). The control technology should consist of one or more of the following: 1. Use of waterborne coatings;2. Use of powder coatings;3. Use of high-solids coatings;4. Carbon adsorption; and6. Any technology of equal or greater control efficiency when compared to the use of coating complying with 9VAC5-40-4030 B 1, provided such technology is approved by the board.C. Three-piece can side-seam spray. The control technology should consist of one or more of the following: 1. Use of waterborne coatings;2. Use of powder coatings; and3. Use of high solids coatings; or4. Any technology of equal or greater control efficiency when compared to the use of coating complying with 9VAC5-40-4030 C 1, provided such technology is approved by the board.D. End sealing compound coating. The control technology should consist of one or more of the following: 1. Use of waterborne coatings;2. Use of high-solids coatings; or3. Any technology of equal or greater control efficiency when compared to the use of coating complying with 9VAC5-40-4030 D 1, provided such technology is approved by the board.9 Va. Admin. Code § 5-40-4040
Derived from VR120-04-2904, eff. July 1, 1991.Statutory Authority
§§ 10.1-1307 and 10.1-1308 of the Code of Virginia.