9 Va. Admin. Code § 5-40-3720

Current through Register Vol. 41, No. 4, October 8, 2024

Section 9VAC5-40-3720 - Definitions

A. For the purpose of these regulations and subsequent amendments or any orders issued by the board, the words or terms shall have the meanings given them in subsection C of this section.

B. As used in this article, all terms not defined here shall have the meanings given them in 9VAC5 Chapter 10 (9VAC5-10-10 et seq.), unless otherwise required by context.

C. Terms defined.

"Application area" means the area where the coating is applied by spraying, dipping or flow coating techniques.

"Coating applicator" means an apparatus used to apply a surface coating.

"Coating application system" means any operation or system where a surface coating of one type or function is applied, dried or cured and which is subject to the same emission standard. May include any equipment which applies, conveys, dries or cures a surface coating, including, but not limited to, spray booths, flow coaters, flashoff areas, air dryers, drying areas and ovens. It is not necessary for a coating application system to have an oven, flashoff area or drying area to be included in this definition.

"Flashoff area" means the space between the application area and the oven.

"Magnet wire coating" means the process of applying a coating, electrically insulating varnish or enamel to aluminum or copper wire for use in electrical machinery.

"Oven" means a chamber within which heat is used to bake, cure, polymerize or dry a surface coating or any combination of those.

9 Va. Admin. Code § 5-40-3720

Derived from VR120-04-2702, eff. July 1, 1991.

Statutory Authority

§ 10.1-1308 of the Code of Virginia.