18 Va. Admin. Code § 15-40-130

Current through Register Vol. 41, No. 8, December 2, 2024

Section 18VAC15-40-130 - Home inspection report

A. Home inspection reports shall contain:

1. Information pertaining to the licensee, including:

a. Licensee's name;

b. Business address;

c. Telephone number; and

d. License number and expiration date, to be followed by "NRS" if so designated and performing a home inspection on a new residential structure;

2. The name, address, and telephone number of the client or the client's authorized representative, if available at the time of the inspection;

3. The physical address of the residential property inspected; and

4. The date, time (to include both start and finish times of the home inspection), and weather conditions at the time of the home inspection.

B. In conducting a home inspection and reporting its findings, the home inspector, at a minimum, shall inspect the condition of and shall describe in writing the composition or characteristics of the following readily accessible components and readily observable defects, except as may be limited in the home inspection contract agreement:

1. Structural system.

a. Foundation.

b. Framing.

c. Stairs.

d. Crawl space; the method of inspecting the crawl space shall be noted and explained in the home inspection report. If the crawl space cannot be inspected, the licensee shall explain in the home inspection report why this component was not inspected.

e. Crawl space ventilation and vapor barriers.

f. Slab floor, when present.

g. Floors, ceilings, and walls.

2. Roof structure, attic, and insulation.

a. Roof covering. The method of inspecting the roof covering shall be noted and explained in the home inspection report. If the roof covering cannot be inspected, the licensee shall explain in the home inspection report why this component was not inspected.

b. Roof ventilation.

c. Roof drainage system, to include gutters and downspouts.

d. Roof flashings, if readily visible.

e. Skylights, chimneys, and roof penetrations, but not antennae or other roof attachments.

f. Roof framing and sheathing.

g. Attic, unless area is not readily accessible.

h. Attic insulation.

3. Exterior of residential building or NRS.

a. Wall covering, flashing, and trim.

b. Readily accessible doors and windows, but not the operation of associated security locks, devices, or systems.

c. Decks, balconies, stoops, steps, porches, attached garages, carports, and any associated railings that are adjacent to the residential building or NRS and on the same property but not associated screening, shutters, awnings, storm windows, detached garages, or storm doors.

d. Eaves, soffits, and fascias where readily accessible from ground level.

e. Walkways, grade steps, patios, and driveways, but not fences or privacy walls.

f. Vegetation, trees, grading, drainage, and any retaining walls adjacent to the residential building or NRS.

g. Visible exterior portions of chimneys.

4. Interior of residential building or NRS.

a. Interior walls, ceilings, and floors of residential building or NRS and any adjacent garage.

b. Steps, stairways, railings, and balconies and associated railings.

c. Countertops and installed cabinets, including hardware.

d. Doors and windows, but not the operation of associated security locks, devices, or systems.

e. Garage doors and permanently mounted and installed garage door operators. The automatic safety reverse function of garage door openers shall be tested, either by physical obstruction as specified by the manufacturer, or by breaking the beam of the electronic photo eye but only when the test can be safely performed and will not risk damage to the door, the opener, any nearby structure, or any stored items.

f. Fireplaces, venting systems, hearths, dampers, and fireboxes, but not mantles, fire screens and doors, seals, and gaskets.

g. Solid fuel burning appliances, if applicable.

5. Plumbing system.

a. Interior water supply and distribution systems, including water supply lines and all fixtures and faucets, but not water conditioning systems or fire sprinkler systems.

b. Water drainage, waste, and vent systems, including all fixtures.

c. Drainage sumps, sump pumps, and related piping.

d. Water heating equipment, including energy source and related vent systems, flues, and chimneys, but not solar water heating systems.

e. Fuel storage and distribution systems for visible leaks.

6. Electrical system.

a. Service drop.

b. Service entrance conductors, cables, and raceways.

c. Service equipment and main disconnects.

d. Service grounding.

e. Interior components of service panels and sub panels, including feeders.

f. Conductors.

g. Overcurrent protection devices.

h. Readily accessible installed lighting fixtures, switches, and receptacles.

i. Ground fault circuit interrupters.

j. Presence or absence of smoke alarms.

k. Presence of solid conductor aluminum branch circuit wiring.

l. Arc fault interrupters shall be noted if installed but not tested if equipment is attached to them.

7. Heating system.

a. Heating equipment, including operating controls, but not heat exchangers, gas logs, built-in gas burning appliances, grills, stoves, space heaters, solar heating devices, or heating system accessories such as humidifiers, air purifiers, motorized dampers, and heat reclaimers.

b. Energy source.

c. Heating distribution system.

d. Vent systems, flues, and chimneys, including dampers.

8. Air conditioning system.

a. Central and installed wall air conditioning equipment.

b. Operating controls, access panels, and covers.

c. Energy source.

d. Cooling distribution system.

C. Systems in the home that are turned off, winterized, or otherwise secured so that they do not respond to normal activation using standard operating controls need not be put into operating condition. The home inspector shall state, in writing, the reason these systems or components were not inspected.

D. For any smoke alarms that are readily accessible in the residential building or NRS, the home inspection report must include a determination of whether the smoke alarms are in good working order as defined in 18VAC15-40-10.

1. A home inspector is not required to operate the test function of a smoke alarm if the smoke alarm is part of a central alarm system or security system in which such testing will automatically alert a fire department or other authority. To the extent the home inspector is unable to determine whether testing will cause an automatic alert, the home inspector is not required to operate the test function of the smoke alarm.

2. If a smoke alarm is not readily accessible or there are any limitations in determining whether it is in good working order, the home inspection report must state that it is not readily accessible or describe such limitations, as applicable.

3. The home inspection report must include the substance of the following: It is recommended that a home have smoke alarms on each level of the dwelling and in every bedroom or sleeping area. Clients should replace any existing smoke alarms that are not in good working order with new ones and install smoke alarms where they may be missing or not properly located. Any test of a smoke alarm during a home inspection only reflects its condition at the time of inspection and is not a guarantee, warranty, or any form of insurance. A test performed during the home inspection does not supersede the smoke alarm manufacturer's testing recommendations. Clients should follow the manufacturer's instructions for proper placement, installation, and maintenance.

E. In accordance with § 54.1-517.2:1 of the Code of Virginia, if a home inspector observes the presence of any shade of yellow corrugated stainless steel tubing during a home inspection in a home that was built prior to the adoption of the 2006 Virginia Construction Code, effective May 1, 2008, the home inspector shall include that observation in the report along with the following statement: "Manufacturers believe that this product is safer if properly bonded and grounded as required by the manufacturer's installation instructions. Proper bonding and grounding of the product should be determined by a contractor licensed to perform the work in the Commonwealth of Virginia."

18 Va. Admin. Code § 15-40-130

Derived from Virginia Register Volume 19, Issue 18, eff. July 1, 2003; amended, Virginia Register Volume 27, Issue 11, eff. April 1, 2011; Amended, Virginia Register Volume 33, Issue 19, eff. 7/1/2017; Amended, Virginia Register Volume 33, Issue 26, eff. 9/20/2017; Amended, Virginia Register Volume 40, Issue 21, eff. 8/1/2024.

Statutory Authority: §§ 54.1-201 and 54.1-501 of the Code of Virginia.