Current through Register Vol. 41, No. 8, December 2, 2024
Section 12VAC5-590-895 - Pre-engineered package treatment unitsA. Pre-engineered package treatment units are defined as predesigned, factory built, and transported virtually assembled to the operation site. The provisions of 12VAC5-590-290 shall apply.B. General design considerations. 1. A rapid mix unit process shall be provided. The design shall meet requirements of 12VAC5-590-871 A.2. Flocculation units shall meet requirements of 12VAC5-590-871 B or as identified and justified in the approved PER.3. Sedimentation units shall meet requirements of 12VAC5-590-872 or as identified and justified in the approved PER.4. Filters shall be dual media or multimedia gravity filters. Design of filtration units shall meet the requirements of 12VAC5-590-874 or as identified and justified in the approved PER.5. Indicating and recording turbidimeters meeting requirements of 12VAC5-590-770 B shall be provided for the:b. Applied water to each filter;c. Filter effluent from each filter; and6. Sufficient overflows and drains shall be provided to maintain a maximum water level within the plant, including the depth of water over the filters, and to facilitate complete draining of the package unit.7. Where automatic unit process control is provided, operator adjustment of chemical feed rates, times, and sequences shall be provided as well as a manual override of all automatic features. a. Automatic start-up of water treatment unit processes is prohibited.b. Valve actuators shall be provided with manual override capability.8. Treatment units installed at ground level shall be provided with stairways, walkways, or other suitable means to allow access for operation and maintenance and observation of all treatment process units. Filters shall be adequately accessible to facilitate evaluation of the entire filter bed for media condition and placement, fluidization during backwashing, and evaluation of compaction during filtration.C. An operation and maintenance manual shall be provided for all pre-engineered package treatment units. The operation and maintenance manual shall include the following: 1. A detailed description of the treatment units and the control of each unit for optimal performance.2. A preventative maintenance schedule.3. Manual adjustment and override procedures for any automatic control features.4. A troubleshooting guide for typical problems.D. The owner shall require the equipment manufacturer to provide onsite start-up and follow-up training.12 Va. Admin. Code § 5-590-895
Derived from Virginia Register Volume 37, Issue 20, eff. 6/23/2021.Statutory Authority: §§ 32.1-12 and 32.1-170 of the Code of Virginia.