Section R315-264-97 - General Ground-Water Monitoring RequirementsThe owner or operator shall comply with the following requirements for any ground-water monitoring program developed to satisfy Sections R315-264-98 through 100:
(a) The ground-water monitoring system shall consist of a sufficient number of wells, installed at appropriate locations and depths to yield ground-water samples from the uppermost aquifer that: (1) Represent the quality of background ground water that has not been affected by leakage from a regulated unit; (i) A determination of background ground-water quality may include sampling of wells that are not hydraulically upgradient of the waste management area where: (A) Hydrogeologic conditions do not allow the owner or operator to determine what wells are hydraulically upgradient; and (B) Sampling at other wells will provide an indication of background ground-water quality that is representative or more representative than that provided by the upgradient wells; and (2) Represent the quality of ground water passing the point of compliance. (3) Allow for the detection of contamination when hazardous waste or hazardous constituents have migrated from the waste management area to the uppermost aquifer. (b) If a facility contains more than one regulated unit, separate ground-water monitoring systems are not required for each regulated unit provided that provisions for sampling the ground water in the uppermost aquifer will enable detection and measurement at the compliance point of hazardous constituents from the regulated units that have entered the ground water in the uppermost aquifer. (c) All monitoring wells shall be cased in a manner that maintains the integrity of the monitoring-well bore hole. This casing shall be screened or perforated and packed with gravel or sand, where necessary, to enable collection of ground-water samples. The annular space, i.e., the space between the bore hole and well casing, above the sampling depth shall be sealed to prevent contamination of samples and the ground water. (d) The ground-water monitoring program shall include consistent sampling and analysis procedures that are designed to ensure monitoring results that provide a reliable indication of ground-water quality below the waste management area. At a minimum the program shall include procedures and techniques for: (2) Sample preservation and shipment; (3) Analytical procedures; and (4) Chain of custody control. (e) The ground-water monitoring program shall include sampling and analytical methods that are appropriate for ground-water sampling and that accurately measure hazardous constituents in ground-water samples. (f) The ground-water monitoring program shall include a determination of the ground-water surface elevation each time ground water is sampled. (g) In detection monitoring or where appropriate in compliance monitoring, data on each hazardous constituent specified in the permit will be collected from background wells and wells at the compliance point(s). The number and kinds of samples collected to establish background shall be appropriate for the form of statistical test employed, following generally accepted statistical principles. The sample size shall be as large as necessary to ensure with reasonable confidence that a contaminant release to ground water from a facility will be detected. The owner or operator shall determine an appropriate sampling procedure and interval for each hazardous constituent listed in the facility permit which shall be specified in the unit permit upon approval by the Director. This sampling procedure shall be: (1) A sequence of at least four samples, taken at an interval that assures, to the greatest extent technically feasible, that an independent sample is obtained, by reference to the uppermost aquifer's effective porosity, hydraulic conductivity, and hydraulic gradient, and the fate and transport characteristics of the potential contaminants, or (2) an alternate sampling procedure proposed by the owner or operator and approved by the Director. (h) The owner or operator shall specify one of the following statistical methods to be used in evaluating ground-water monitoring data for each hazardous constituent which, upon approval by the Director, shall be specified in the unit permit. The statistical test chosen shall be conducted separately for each hazardous constituent in each well. Where practical quantification limits (pql's) are used in any of the following statistical procedures to comply with Subsection R315-26497(i)(5), the pql shall be proposed by the owner or operator and approved by the Director. Use of any of the following statistical methods shall be protective of human health and the environment and shall comply with the performance standards outlined in Subsection R315-264-97(i). (1) A parametric analysis of variance, ANOVA, followed by multiple comparisons procedures to identify statistically significant evidence of contamination. The method shall include estimation and testing of the contrasts between each compliance well's mean and the background mean levels for each constituent. (2) An analysis of variance, ANOVA, based on ranks followed by multiple comparisons procedures to identify statistically significant evidence of contamination. The method shall include estimation and testing of the contrasts between each compliance well's median and the background median levels for each constituent. (3) A tolerance or prediction interval procedure in which an interval for each constituent is established from the distribution of the background data, and the level of each constituent in each compliance well is compared to the upper tolerance or prediction limit. (4) A control chart approach that gives control limits for each constituent. (5) Another statistical test method submitted by the owner or operator and approved by the Director. (i) Any statistical method chosen under Subsection R315-264-97(h) for specification in the unit permit shall comply with the following performance standards, as appropriate: (1) The statistical method used to evaluate ground-water monitoring data shall be appropriate for the distribution of chemical parameters or hazardous constituents. If the distribution of the chemical parameters or hazardous constituents is shown by the owner or operator to be inappropriate for a normal theory test, then the data should be transformed or a distribution-free theory test should be used. If the distributions for the constituents differ, more than one statistical method may be needed. (2) If an individual well comparison procedure is used to compare an individual compliance well constituent concentration with background constituent concentrations or a ground-water protection standard, the test shall be done at a Type I error level no less than 0.01 for each testing period. If a multiple comparisons procedure is used, the Type I experiment wise error rate for each testing period shall be no less than 0.05; however, the Type I error of no less than 0.01 for individual well comparisons shall be maintained. This performance standard does not apply to tolerance intervals, prediction intervals or control charts. (3) If a control chart approach is used to evaluate ground-water monitoring data, the specific type of control chart and its associated parameter values shall be proposed by the owner or operator and approved by the Director if he or she finds it to be protective of human health and the environment. (4) If a tolerance interval or a prediction interval is used to evaluate groundwater monitoring data, the levels of confidence and, for tolerance intervals, the percentage of the population that the interval shall contain, shall be proposed by the owner or operator and approved by the Director if he or she finds these parameters to be protective of human health and the environment. These parameters shall be determined after considering the number of samples in the background data base, the data distribution, and the range of the concentration values for each constituent of concern. (5) The statistical method shall account for data below the limit of detection with one or more statistical procedures that are protective of human health and the environment. Any practical quantification limit (pql) approved by the Director under Subsection R315-264-97(h) that is used in the statistical method shall be the lowest concentration level that can be reliably achieved within specified limits of precision and accuracy during routine laboratory operating conditions that are available to the facility. (6) If necessary, the statistical method shall include procedures to control or correct for seasonal and spatial variability as well as temporal correlation in the data. (j) Ground-water monitoring data collected in accordance with Subsection R315-264-97(g) including actual levels of constituents shall be maintained in the facility operating record. The Director shall specify in the permit when the data shall be submitted for review. Utah Admin. Code R315-264-97
Adopted by Utah State Bulletin Number 2016-9, effective 4/15/2016