Utah Admin. Code 307-335-6

Current through Bulletin No. 2024-21, November 1, 2024

Section R307-335-6 - Conveyorized Degreasers

Owners and operators of conveyorized degreasers shall, in addition to meeting the requirements of R307-335-4(3), (4) and (5) and R307-335-5(5):

(1) Install one of the following control devices for conveyorized degreasers with an air/vapor interface equal to or greater than two square meters (21.5 square feet):

(a) Refrigerated chiller; or

(b) Carbon adsorption system, with ventilation greater than or equal to 15 cubic meters per minute per square meter (50 cubic feet per minute per square foot) of air/vapor area when downtime covers are open, and exhausting less than 25 parts per million of solvent, by volume, averaged over a complete adsorption cycle.

(2) Equip the cleaner with equipment, such as a drying tunnel or rotating (tumbling) basket, sufficient to prevent cleaned parts from carrying out solvent liquid or vapor.

(3) Provide downtime covers for closing off the entrance and exit during shutdown hours. Ensure that down-time cover is placed over entrances and exits of conveyorized degreasers immediately after the conveyor and exhaust are shut down and is removed just before they are started up.

(4) Minimize carryout emissions by racking parts for best drainage and maintaining the vertical conveyor speed at less than 3.3 meters per minute (11 feet per minute).

(5) Minimize openings: Entrances and exits should silhouette work loads so that the average clearance (between parts and the edge of the degreaser opening) is either less than 10 cm (4 inches) or less than 10% of the width of the opening.

(6) Install safety switches on the following:

(a) Condenser flow switch and thermostat - shuts off sump heat if coolant is either not circulating or too warm;

(b) Spray switch - shuts off spray pump or conveyor if the vapor level drops excessively, i.e., greater than 10 cm or (4 inches); and

(c) Vapor level control thermostat - shuts off sump level if vapor level rises too high.

(7) Ensure that solvent is not visibly detectable in the water exiting the water separator.

Utah Admin. Code R307-335-6

Amended by Utah State Bulletin Number 2017-22, effective 10/29/2017