Section R27-10-2 - Identification Markings(1) The standard identification mark shall be a likeness of the Great Seal of the state of Utah. (a) Light-, Medium-, and Heavy-duty trucks, service vehicles, and off-road equipment shall be clearly marked, on each front door, with an eight-inch State Seal. At the option of the entity operating the state vehicle or equipment, the identification mark may include a banner not more than four inches high which may bear the agency's logo and the name of the department or division. All identification markings must be approved by the division before use.(b) Non-law enforcement passenger vehicles shall be marked with a translucent identification sticker, four inches in diameter on the furthest rearward window in the lower-most rearward corner, on each side of the vehicle.(2) Identification mark requirements are not intended to preclude other markings used to identify special purpose vehicles.(3) Vehicles used for law enforcement purposes may, at the discretion of the operating agency, display a likeness of the Great Seal of the state of Utah in the center of a gold star for identification purposes. Other emergency response vehicles are not precluded from displaying additional appropriate markings. At the option of the agency, the State Seal may be placed on the front door above any molding and, where practicable, shall be at least four inches below the window. The optional banner portion of the identification mark shall be placed immediately below the State Seal.(4) Identification markings shall clearly identify vehicles or equipment as being the property of the state. Additional markings should be applied with discretion so as not to detract from that intent.Utah Admin. Code R27-10-2
Amended by Utah State Bulletin Number 2022-07, effective 3/14/2022Amended by Utah State Bulletin Number 2023-05, effective 2/21/2023