S.D. Admin. R. 74:52:02:09

Current through Register Vol. 51, page 54, October 28, 2024

Section 74:52:02:09 - Application requirements for new sources and new discharges

In addition to the information required by § 74:52:02:08, new manufacturing, commercial, mining, and silvicultural dischargers applying for SWD permits must provide the following information to the secretary, using application forms provided by the secretary:

(1) The location of the outfalls, including the latitude and longitude to the nearest 15 seconds, and the name of the receiving water;

(2) The expected date of commencement of discharge;

(3) The flows, sources of pollution, and treatment technologies, including the following:

(a) A description of the treatment that the wastewater will receive, along with all operations contributing wastewater to the effluent, average flow contributed by each operation, and the ultimate disposal of any solid or liquid wastes not discharged. The average flow of point sources composed of storm water may be estimated. The basis for the rainfall event and the method of estimation must be indicated;

(b) A line drawing of the water flow through the facility with a water balance, showing operations contributing wastewater to the effluent and treatment units. Similar processes, operations, or production areas may be indicated as a single unit, labeled to correspond to the more detailed identification under subdivision (c) of this section. The water balance shall show approximate average flows at intake and discharge points and between units, including treatment units. If a water balance cannot be determined, the applicant may provide a pictorial description of the nature and amount of any sources of water and any collection and treatment measures; and

(c) If any of the expected discharges will be intermittent or seasonal, a description of the frequency, duration, and maximum daily flow rate of each discharge occurrence, except for storm water runoff, spillage, or leaks;

(4) If a new source performance standard promulgated under § 306 of the CWA (40 C.F.R. Parts 405 to 699, July 1, 1991) or an effluent limitation guideline applies to the applicant and is expressed in terms of production or another measure of operation, a reasonable measure of the applicant's expected actual production reported in the units used in the applicable effluent guideline or new source performance standard for each of the first three years. Alternative estimates may also be submitted if production is likely to vary;

(5) Estimates of pollutants expected to be present in a discharge. The applicant shall indicate if the pollutant is present solely due to the intake water. All levels, except for discharge flow, temperature, and pH, must be estimated as concentration and as total mass. Applicants must report the following:

(a) Estimated daily maximum, daily average, and the source of information for each outfall for the following pollutants or parameters. The secretary may waive the reporting requirements of any of these pollutants and parameters if the applicant submits a request for such a waiver before or with the application which demonstrates that information adequate to support issuance of the permit can be obtained through less stringent reporting requirements:

(i) Biochemical oxygen demand (BOD);

(ii)Chemical oxygen demand (COD);

(iii) Total organic carbon (TOC);

(iv) Total suspended solids (TSS);

(v) Flow;

(vi) Ammonia (as N);

(vii) Temperature (winter and summer); and

(viii) pH;

(b) Estimated daily maximum, daily average, and the source of information for each outfall for the pollutants in § 74:52:02:43 if the applicant knows or has reason to believe they will be present or if they are limited by an effluent limitation guideline or new source performance standard either directly or indirectly through limitations on an indicator pollutant;

(c) Estimated daily maximum, daily average, and source of information for the following pollutants if the applicant knows or has reason to believe that they will be present in the discharges from any outfall:

(i) The toxic metals, cyanide, and total phenols listed in § 74:52:02:42;

(ii)The organic toxic pollutants in § 74:52:02:41 by GC/MS fraction and as required by the industrial categories in § 74:52:02:39;

-

(d) That 2, 3, 7, 8 tetrachlorodibenzo-p-dioxin (TCDD) may be discharged if the applicant uses or manufactures one of the following compounds or if the applicant knows or has reason to believe that TCDD will or may be present in an effluent:

(i) 2,4,5-trichlorophenoxy acetic acid (2,4,5-T) {Chemical Abstract Services (CAS) # 93-76-5 };

(ii)2-(2,4,5-trichlorophenoxy) propanoic acid (Silvex, 2,4,5-TP) (CAS # 93-72-1);

(iii) 2-(2,4,5-trichlorophenoxy) ethyl 2,2-dichloropropionate (Erbon) (CAS # 136-25-4);

(iv) 0,0-dimethyl 0-(2,4,5-trichlorophenyl) phosphorothioate (Ronnel) (CAS # 299-84-3);

(v) 2,4,5-trichlorophenol (TCP) (CAS # 95-95-4); or

(vi) Hexachlorophene (HCP) (CAS # 70-80-4);

(e) Any hazardous substances listed in § 74:52:02:44 if the applicant believes they will be present in any outfall. No quantitative estimates are required unless they are already available;

(f) No later than two years after the commencement of a discharge from the proposed facility, the applicant must complete and submit items V and VI of the SWD permit application form. However, the applicant need not complete those portions of item V requiring tests which the applicant has already performed and reported under the discharge monitoring requirements of the applicant's SWD permit;

(6) The existence of any technical evaluation concerning the applicant's wastewater treatment, along with the name and location of similar plants of which the applicant has knowledge; and

(7) Any optional information the applicant wishes to have considered.

S.D. Admin. R. 74:52:02:09

14 SDR 86, effective 12/24/1987; transferred from

General Authority: SDCL 34A-2-30.

Law Implemented: SDCL 34A-2-40, 34A-2-44.