Article 12 - INTERNATIONAL RESIDENTIAL CODE
- Section 8-1200 - International Residential Code
- Section 8-1201 - IRC R202 Definitions
- Section 8-1202 - IRC R301.2.1 Wind Design criteria
- Section 8-1203 - IRC R301.2.2.1 Determination of seismic design category
- Section 8-1204 - IRC Figure R302.1 Exterior walls
- Section 8-1205 - IRC R302.4.1 Through penetrations
- Section 8-1206 - IRC R302.5.1 Opening protection
- Section 8-1207 - R.302.13 Fire Protection of Floors
- Section 8-1208 - IRC R303.4 Mechanical ventilation
- Section 8-1209 - IRC Figure R307.1 Minimum Fixture Clearances
- Section 8-1210 - IRC R311.7.5.1 Risers
- Section 8-1211 - IRC R312.1.1 Where required
- Section 8-1212 - IRC R312.2 Window Fall Protection
- Section 8-1213 - IRC R313 Automatic Fire Sprinkler Systems
- Section 8-1214 - IRC R317.1.1 Field treatment
- Section 8-1215 - IRC 318.1 Subterranean termite control methods
- Section 8-1216 - IRC R318.4 Foam Plastic Protection
- Section 8-1217 - IRC 318.5 Termite Inspection Strip
- Section 8-1218 - IRC R322.1 General
- Section 8-1219 - IRC R326.3 Story above grade plane
- Section 8-1220 - IRC R404.1.9.2 Masonry piers supporting floor girders
- Section 8-1221 - IRC R408.3 Unvented Crawl Space
- Section 8-1222 - IRC R408.4 Access
- Section 8-1223 - IRC R408.8 Under-floor vapor retarder
- Section 8-1224 - IRC R502.11.4 Truss design drawings
- Section 8-1225 - IRC R506.2.3 Vapor Retarder
- Section 8-1226 - IRC R606.7 Piers
- Section 8-1227 - IRC R802.10.1 Wood Truss Design
- Section 8-1228 - IRC R905.2.8.5 Drip Edge
- Section 8-1229 - IRC M1411.6 Insulation of refrigerant piping
- Section 8-1230 - IRC Chapter 11 Energy Efficiency
- Section 8-1231 - IRC M1411.9 Locking access port caps
- Section 8-1232 - IRC M1502.3 Duct termination
- Section 8-1233 - IRC M1502.4.2 Duct Installation
- Section 8-1234 - IRC M1502.4.6 Duct length
- Section 8-1235 - IRC M1503.6 Makeup air required
- Section 8-1236 - IRC M1504.3 Exhaust Openings
- Section 8-1237 - IRC M1601.4.1 Joints, seams and connections
- Section 8-1238 - IRC G2418.2 Design and Installation
- Section 8-1239 - IRC P2503.6 Shower Liner Test
- Section 8-1240 - IRC P2603.2.1 Protection against physical damage
- Section 8-1241 - IRC P2603.5 Freezing
- Section 8-1242 - IRC P2705.1 General
- Section 8-1243 - IRC P2708.4 Shower control valves
- Section 8-1244 - IRC P2713.3 Bathtub and whirlpool bathtub valves
- Section 8-1245 - IRC P2903.10 Hose Bibb
- Section 8-1246 - IRC P2904.2.4.2.1 Additional requirements for pendent sprinklers
- Section 8-1247 - IRC E3606.5 Surge protection
- Section 8-1248 - IRC E3802.4 In unfinished basements
- Section 8-1249 - IRC R3901.4.2.1 Islands and peninsular countertops and work spaces
- Section 8-1250 - IRC E3902 Ground-Fault and Arc-Fault Circuit-Interrupter Protection
- Section 8-1251 - IRC E3902.5 Basement receptacles
- Section 8-1252 - IRC R3902.17 Arc Fault Circuit Interrupted Protection
- Section 8-1253 - IRC E4002.14. Tamper-resistant receptacles
- Section 8-1254 - IRC Chapter 44 Referenced Standards
- Section 8-1255 - IRC Appendix AH Patio Covers
- Section 8-1256 - IRC Appendix AJ Existing Buildings
- Section 8-1257 - IRC Appendix AQ Tiny Houses