Current through Register Vol. 54, No. 44, November 2, 2024
Section 105.14 - Required equipmentThe following equipment is required for the operation of a maintenance and calibration station. Suitable manufacturers and model numbers are listed, however, equivalent equipment or an alternative technique approved by the Communications Division, State Police is acceptable:
(1) Power supply-Hewlett Packard Model 6177C.(2) Frequency counter-Hewlett Packard Model 5314A.(3) Power Meter and Thermistor Mounts-Hewlett Packard Models 432A, X486A and K486A.(4) Multimeter-Hewlett Packard Model 410C.(5) AC Voltmeter-Hewlett Packard Model 400D or Leader Model LMV-181A.(6) Function Generator-Hewlett Packard Model 3311A.(7) Variable Attenuators-Hewlett Packard Models X382A and K382A.(8) RF Absorption Chamber-See Appendix A, Figure 1.(9) Frequency Counter-Hewlett Packard Models 5342A or 5343A.(10) Calibrated Antennas-Narda Models 638 and 640.(11) Coaxial Adapters-Narda Models 4601 and 4608B.(12) Pin Diode Switch-General Microwave F9114.(13) Microphone-Electrovoice 631A.(14) 4 Watt HF or VHF-AM Modulated Signal Source.(15) Base Loaded Whip Antenna Tuned to paragraph (14).The provisions of this §105.14 adopted August 26, 1977, effective 8/27/1977, 7 Pa.B. 2422; republished and compiled August 1, 1980, effective 8/2/1980, 10 Pa.B. 3199; amended January 15, 1982, effective 1/16/1982, 12 Pa.B. 299; readopted December 4, 1987, effective 12/5/1987, 17 Pa.B. 5051; amended February 17, 1989, effective 2/18/1989, 19 Pa.B. 640. This section cited in 67 Pa. Code § 105a.4 (relating to system and speed timing device use and certification).