Current through Register Vol. 54, No. 37, September 14, 2024
Section 279.213 - Access roads(a) An access road shall be designed, constructed and maintained to prevent erosion to the maximum extent possible and to prevent contributions of sediment to streams or runoff outside the site.(b) A crossing of a perennial or intermittent stream or a wetland shall be made using bridges, culverts or similar structures. Bridges, culverts or other encroachments or water obstructions shall meet the requirements of Chapter 105 (relating to dam safety and waterway management).(c) An access road shall have a drainage system that is compatible with the natural drainage system, structurally stable and which will pass safely the peak flow from a 25-year, 24-hour precipitation event. The drainage system shall also comply with Chapter 102 (relating to erosion control).(d) An access road shall be paved or surfaced with asphalt, gravel, cinders or other equivalent material approved by the Department in the permit. An access road shall be capable of withstanding the load limits projected by the applicant under § 279.104 (relating to plan for access roads). The maximum sustained grade of an access road may not exceed 12%.(e) An access road negotiable by loaded collection vehicles shall be provided from the entrance gate of the area to unloading areas, treatment facilities or impoundments.(f) A road shall be constructed on a base that is capable of withstanding anticipated loads.(g) Disturbed areas adjacent to a road shall be vegetated or otherwise stabilized to prevent erosion.(h) An access road shall be maintained to control dust and to prevent and control the tracking of mud on and off the site.The provisions of this §279.213 amended December 22, 2000, effective 12/23/2000, 30 Pa.B. 6685. This section cited in 25 Pa. Code § 279.104 (relating to plan for access roads).