25 Pa. Code § 252.1
The following words and terms, when used in this chapter, have the following meanings, unless the context clearly indicates otherwise:
Acceptance criteria-Specified limits placed on a measurement, quality control sample or process.
Accreditation-A determination by the Department that an environmental laboratory is capable of performing one or more classes of testing or analysis of environmental samples in accordance with the act and this chapter.
Accreditation body-A territorial, State or Federal agency having responsibility and accountability for environmental laboratory accreditation and which grants accreditation.
Accreditation-by-rule-Accreditation which an environmental laboratory is deemed to have for the fields of accreditation identified in § 252.6 (relating to accreditation-by-rule) upon compliance with that section.
Act-27 Pa.C.S. §§ 4101-4113 (relating to environmental laboratory accreditation).
Action level-The concentration of a contaminant which, if exceeded, triggers a treatment or other requirement which a water system must follow.
Analysis day-A continuous 24-hour period during which testing or analysis of environmental samples is performed.
Analyst-An individual who performs the analytical methods and associated techniques and who is responsible for applying the required laboratory practices and quality controls to meet the required level of quality.
Analyte-The component, compound, element or isotope to be identified or quantified using a test or analysis.
Batch-Environmental samples that are prepared or analyzed together using the same procedures, personnel, lots of reagents and standards.
Batch, analytical-A batch composed of prepared environmental samples that are analyzed together as a group. An analytical batch may contain samples originating from various environmental matrices and can exceed 20 samples.
Batch, preparation-A batch composed of 1 to 20 environmental samples of the same matrix with a maximum time between the start of processing of the first and last sample in the batch to be 24 hours.
Calibration verification standard-A standard used to confirm the validity of a previously performed initial calibration of a measurement process.
Certificate of accreditation-A document issued by the Department certifying that an environmental laboratory has met standards for accreditation.
Commonwealth agency-An agency that is a Commonwealth agency as that term is defined under 62 Pa.C.S. § 103 (relating to definitions.)
Deficiency-A deviation from acceptable procedures or practices.
Detection limit-The lowest concentration or amount of the target analyte that can be identified, measured and reported with confidence that the analyte concentration is not zero.
Drinking water-Any aqueous sample that has been collected for the purposes of demonstrating compliance with the Pennsylvania Safe Drinking Water Act (35 P. S. §§ 721.1-721.17) or is from a potable or potential potable water source.
ECp-Effective concentration percent-The concentration that affects the test variable at p percent from the control value.
Environmental laboratory-A facility engaged in the testing or analysis of environmental samples.
Environmental sample-A solid, liquid, gas or other specimen taken for the purpose of testing or analysis as required by an environmental statute.
Environmental statute-A statute administered by the Department relating to the protection of the environment or of public health, safety and welfare.
Facility-A sole proprietor, partnership, corporation, association, institution, cooperative enterprise, municipal authority, political subdivision, Federal government or agency, state institution or agency or other legal entity which is recognized by law as the subject of rights and duties.
Field of accreditation-A combination of matrix; method or technology, or both; and analyte or analyte group for which an environmental laboratory may be accredited. Examples are:
Holding time-The maximum elapsed time from sample collection to initiation of testing or analysis.
ICp-Inhibition concentration percent-The concentration that inhibits the test variable at p percent from the control value.
Industrial wastewater treatment facility-Any facility that treats industrial waste or pollution, but not sewage, as those terms are defined in The Clean Streams Law (35 P. S. §§ 691.1-691.1001).
Initial calibration-Determination by measurement or comparison with a standard of known concentration the correct value or response of each scale reading on a meter, instrument or other device. Comparison of a measurement standard or instrument with another standard or instrument to report or eliminate by adjustment any variation in the accuracy of the item being compared.
Initial demonstration of capability-A procedure to establish the ability of an analyst, technical staff member or work cell to generate data of acceptable accuracy and precision.
LCp-Lethal concentration percent-The concentration that is lethal to p percent of the test organisms from the control organisms.
Laboratory control sample-A sample of a controlled matrix known to be free of the analyte of interest, to which a known and verified concentration of analyte has been added and that is taken through all preparation and analytical steps in the method.
Laboratory management-
Laboratory notebook-A chronological record of observations, results of testing or analysis, equipment maintenance or calibration or other environmental laboratory data. A laboratory notebook may be maintained in an electronic format.
Laboratory supervisor-A technical supervisor of an environmental laboratory who supervises laboratory procedures and reporting of analytical data.
Linear range-The range of concentrations over which the instrument response is directly proportional to the analyte concentration.
MCL-Maximum Contaminant Level-The maximum permissible level of a contaminant in water which is delivered to a user of a public water system, and includes the primary and secondary MCLs established under the Safe Drinking Water Act (42 U.S.C.A. §§ 300f-300j-10) and MCLs adopted under the Pennsylvania Safe Drinking Water Act and the regulations promulgated thereunder.
Matrix or matrices-The media of an environmental sample that includes drinking water, nonpotable water, and solid and chemical materials.
Matrix spike-A sample prepared by adding a known mass of target analyte to a specified amount of environmental sample and that is taken through all preparation and analytical steps in the method.
Method-The scientific technique used to perform testing or analysis on an environmental sample.
Method blank-A sample of a known matrix, similar to the associated samples, and known to be free of the analyte of interest and that is taken through all preparation and analytical steps in the method.
Mobile laboratory-
NELAC-National Environmental Laboratory Accreditation Conference.
NELAP-National Environmental Laboratory Accreditation Program.
NELAP accreditation body-An accreditation body that has been recognized as meeting the requirements of the NELAC Standard or the TNI Standard and has the authority to grant NELAP accreditation.
NIST-The National Institute of Standards and Technology of the United States Department of Commerce's Technology Administration.
NOAEC-No observed adverse effect concentration.
NOEC-No observed effect concentration.
Negative culture control-An organism selected to demonstrate that the medium does not support the growth of nontarget organisms or does not demonstrate the typical positive reaction of the target organisms.
Nonpotable water-
Positive culture control-An organism selected to demonstrate that the medium can support the growth of the target organisms and that the medium produces the specified or expected reaction to the target organism.
Primary accreditation-Accreditation received from the Department that is not based upon accreditation from another accreditation body.
Proficiency test reporting limit-The value that corresponds to the lowest acceptable result that could be obtained from the lowest spike level for each analyte in a proficiency test sample.
Proficiency test study-A sample or group of samples, the composition of which is unknown to the environmental laboratory and the analyst.
Promulgated method-A protocol for testing or analysis of a specific analyte that is approved for use by a State or Federal regulation.
Quality manual-A document stating, or making reference to, the policies, objectives, principles, responsibilities, accountability, implementation plans, methods, operating procedures or other documents of an environmental laboratory for ensuring the quality of its testing and analysis.
Quantitation limit-The minimum concentration or activity of the component, compound, element or isotope that can be reported with a specified degree of confidence. Typically it is the concentration that produces a signal ten standard deviations above the reagent water blank signal.
Range of quantitation-The concentration range between which an environmental laboratory reports results quantitatively which is defined by a low concentration standard and a high concentration standard.
Reagent water-Water with no detectable concentration of the component, compound, element or isotope to be analyzed and that is free of substances that interfere with the method. Reagent water may be prepared by distillation, ion exchange, adsorption, reverse osmosis or a combination thereof.
Revocation-Removal by the Department of one or more fields of accreditation from an environmental laboratory.
Sample duplicate-Replicate aliquots of the same sample taken through the entire analytical procedure.
Secondary accreditation-Accreditation received from the Department based upon the accreditation status granted by another accreditation body.
Solid and chemical materials-Soils, sediments, sludges, solid waste, drill cuttings, overburden, minerals, coal ash, and products and by-products of an industrial process that result in a matrix that is not otherwise defined.
Solid waste-Any waste, including, but not limited to, municipal, residual or hazardous wastes, including solid, liquid, semisolid or contained gaseous materials as that term is defined in the Solid Waste Management Act (35 P. S. §§ 6018.101-6018.1003).
Spike-A known and verified mass or activity of the target analyte of interest added to reagent water or environmental sample to determine recovery efficiency or for other quality control purposes.
Standard operating procedure-A written document that provides detailed instructions for the performance of all aspects of test, analysis, operation or action.
Surrogate-A substance with properties similar to the analyte of interest. A surrogate is unlikely to be found in an environmental sample. A surrogate is added to an environmental sample prior to all preparation and analytical steps in the method for quality control purposes.
Suspension-The temporary removal by the Department of one or more fields of accreditation from an environmental laboratory for a period not to exceed 6 months.
Technical staff-Employees of an environmental laboratory that perform any portion of testing or analysis of environmental samples, including the analysts of the environmental laboratory.
Test-A technical operation that consists of the determination of one or more characteristics or performance of a given product, material, equipment, organism, physical phenomenon, process or service according to a specified procedure.
TNI-The NELAC Institute or its successor organization/Standard.
Wastewater-A substance that contains the waste products or excrement or other discharge from the bodies of human beings or animals and noxious or deleterious substances being harmful or inimical to the public health, or to animal or aquatic life, or to the use of water for domestic water supply or for recreation, or which constitutes pollution under The Clean Streams Law.
Wastewater facility-A facility that operates a system designed to collect, convey or treat wastewater and from which effluent is discharged into waters of this Commonwealth.
Work area-The areas in an environmental laboratory necessary for testing and analysis and related activities. These areas include sample receipt area, sample storage area, chemical and waste storage area, data handling area and analytical areas.
Work cell-A defined group of analysts that together perform testing or analysis of environmental samples.
25 Pa. Code § 252.1
The provisions of this § 252.1 amended under 27 Pa.C.S. §§ 4103(a), 4104 and 4105; and section 1920-A of The Administrative Code of 1929 (71 P.S. § 510-20).