25 Pa. Code § 129.64

Current through Register Vol. 54, No. 44, November 2, 2024
Section 129.64 - Cutback asphalt paving
(a) After April 30, 1982, no person may permit the use or application of cutback asphalt for paving operations except when any of the following applies:
(1) Long-life stockpile is necessary.
(2) The use or application between October 31 and April 30, is necessary.
(3) The cutback asphalt is used solely as a tack coat, a penetrating prime coat, a dust palliative or precoating of aggregate.
(4) Skin patching is necessary during October. Skin patching shall be less than 500 feet continuous length, 1300 linear feet per mile or 1750 square yards per lane mile.
(b) After April 30, 1982, emulsion asphalts may not contain more than the maximum percentage of solvent as shown in Table 2.

Table 2

Emulsion GradeType% Solvent, Max.
E-1Rapid Setting0
E-2Rapid Setting (Anionic)0
E-3Rapid Setting (Cationic)3
E-4Medium Setting12
E-5Medium Setting12
E-6Slow Setting (Soft Residue)0
E-8Slow Setting (Hard Residue)0
E-10Medium Setting (High Float)7
E-11High Float7
E-12Medium Setting (Cationic)8

25 Pa. Code § 129.64

The provisions of this §129.64 adopted April 27, 1979, effective 8/1/1979, 9 Pa.B. 1447; corrected May 11, 1979, effective 8/1/1979, 9 Pa.B. 1534; amended June 19, 1981, effective 6/20/1981, 11 Pa.B. 2118; amended August 12, 1983, effective 8/13/1983, 13 Pa.B. 2478; corrected September 9, 1983, effective 8/13/1983.

The provisions of this §129.64 issued under section 5 of the Air Pollution Control Act (35 P.S. § 4005).

This section cited in 25 Pa. Code § 129.51 (relating to general); 25 Pa. Code § 129.54 (relating to seasonal operation of auxiliary incineration equipment); 25 Pa. Code § 129.91 (relating to control of major sources of NOx and VOCs); 25 Pa. Code § 129.96 (relating to applicability); and 25 Pa. Code § 129.111 (relating to applicability).