Current through Register Vol. 54, No. 44, November 2, 2024
Section 109.1306 - Information describing 4-log treatment and compliance monitoring(a) Community water systems, noncommunity water systems which hold a valid operation permit under § 109.504 (relating to public water system operation permits) and bottled water and vended water systems, retail water facilities and bulk water hauling systems which hold a valid permit under § 109.1005 (relating to permit requirements) demonstrating at least 4-log treatment of viruses under § 109.1302 (relating to treatment technique requirements) shall submit information in writing on forms provided by the Department and may include plans, specifications, engineer's report, water quality analyses and other data, information or documentation reasonably necessary to enable the Department to evaluate: (1) Treatment effectiveness.(2) The methodology the system will use to comply with § 109.1305 (relating to compliance monitoring).(b) A noncommunity water system not covered under subsection (a) demonstrating at least 4-log treatment of viruses under § 109.1302 shall: (1) File an amendment to the system description as described under § 109.505(a)(2)(ii) (relating to requirements for noncommunity water systems).(2) Submit an application for a noncommunity water system 4-log treatment of groundwater sources permit. The application shall be submitted in writing on forms provided by the Department.(3) Submit plans, specifications, engineer's report, water quality analyses and other data, information or documentation reasonably necessary to enable the Department to determine compliance with the act and this chapter. The Department will make available to the applicant the Public Water Supply Manual, available from the Bureau of Safe Drinking Water, Post Office Box 8467, Harrisburg, Pennsylvania 17105 which contains acceptable design standards and technical guidance. Water quality analyses shall be conducted by a laboratory accredited under this chapter. (c) Plans, specifications and engineer's reports must comply with the following: (1) The drawings, specifications and engineer's report shall be prepared by or under the supervision of a professional engineer registered to practice in this Commonwealth or in the state in which the public water system is located.(2) The front cover or flyleaf of each set of drawings, of each copy of the engineer's report, and of each copy of specifications must bear the signature and imprint of the seal of the registered engineer. Drawings must bear an imprint or a legible facsimile of the seal.The provisions of this §109.1306 adopted December 24, 2009, effective 12/26/2009, 39 Pa.B. 7279; amended August 17, 2018, effective 8/18/2018, 48 Pa.B. 4974.The provisions of this §109.1306 amended under section 4(a) of the Pennsylvania Safe Drinking Water Act (35 P.S. § 721.4(a)); and section 1920-A(b) of The Administrative Code of 1929 (71 P.S. § 510-20(b)).
This section cited in 25 Pa. Code § 109.505 (relating to requirements for non-community water systems); 25 Pa. Code § 109.1302 (relating to treatment technique requirements); and 25 Pa. Code § 109.1307 (relating to system management responsibilities).