Current through Register Vol. 54, No. 45, November 9, 2024
Section 87.92 - Signs and markers(a) Each person who conducts surface mining activities shall identify the operation for the duration of the surface mining activities by posting and maintaining a sign which will be clearly visible at the junction of each haul road and public road. The sign shall be constructed of a durable, weather-resistant material and shall be of a minimum size of 2 feet by 3 feet with a light background and contrasting letters and numbers of a minimum height of 1 1/2 inches that can be easily seen and read. The sign shall show the name, business address and telephone number of the person who conducts the surface mining activities and the identification number of the current permit authorizing surface mining activities.(b) Perimeter, buffer zone and topsoil markers shall: (1) Be posted and maintained during the duration of the surface mining activities to which they pertain.(2) Be clearly visible, readable and uniform throughout the operation.(3) Be made of durable material.(4) Conform to local zoning ordinances and codes.(c) The perimeter of a permit area shall be clearly marked before the beginning of surface mining activities.(d) Stream buffer zones shall be marked along the boundaries of the areas not to be disturbed as required under § 86.102 (relating to areas where mining is prohibited or limited).(e) When topsoil or other vegetation-supporting material is segregated and stockpiled as required under § 87.98 (relating to topsoil: storage), the stockpiled material shall be clearly marked.(f) If blasting is conducted as part of the operation, the person who conducts the surface mining activities shall post and maintain signs and markers as required by § 87.127 (relating to use of explosives: surface blasting requirements).(g) Groundwater and surface water monitoring locations and sampling points used to obtain background information shall be clearly marked and identified. The identification of monitoring locations and sampling points shall correspond with the identification used in the permit application. Markers used to identify monitoring locations shall be made of durable material. The Department may waive marking requirements in cases where the monitoring location or sampling point is obvious or where marking would be objectionable for aesthetic reasons.The provisions of this §87.92 adopted December 19, 1980, 10 Pa.B. 4789, effective 7/31/1982, 12 Pa.B. 2382; amended July 30, 1982, 12 Pa.B. 2473, effective 7/31/1982, 12 Pa.B. 2382; amended December 15, 1995, effective 12/16/1995, 25 Pa.B. 5821.The provisions of this §87.92 amended under the Surface Mining Conservation and Reclamation Act (52 P. S. §§ 1396.1-1396.19a); the Bituminous Mine Subsidence and Land Conservation Act (52 P. S. §§ 1406.1-1406.21); The Clean Streams Law (35 P. S. §§ 691.1-691.1001); and section 1920-A of The Administrative Code of 1929 (71 P. S. § 510-20).