Section 69-10-04-02.3 - Placing in service permitsUpon acceptance and approval of an application, the commission shall issue a placing in service permit to the registered service person. All permits issued under this section remain the property of the commission and must be surrendered upon demand. Permits issued will be either probationary or annual as defined in this section. Permits must be carried at all times while conducting weighting or measuring device servicing or certification and must be produced upon request.
1.Probationary permits.a. An annual permitholder's permit may be downgraded to probationary for not performing proper tests and inspections or other violations deemed relevant by the commission;b. The duration of the probationary permit will be at the discretion of the commission but will not exceed six months from the effective date ; andc. A probationary permitholder shall be accompanied by, and have each placing in service test report cosigned by, an annual permitholder from the same service company and qualified in the same weighing or measuring device category in order for the test report or the placing in service to be considered valid.2.Annual permits.a. An applicant who has met the work history or experience requirements of a registered service person and satisfactorily completed all required tests will receive an annual permit;b. An applicant who has previously held an annual permit by the commission within the last two years, but has allowed it to expire, is eligible for permit reinstatement; andc. A probationary permitholder who has completed probationary time or requirements without receiving any quality assurance failures will receive an annual permit.N.D. Admin Code 69-10-04-02.3
Effective May 1, 2005; amended effective October 1, 2010.Amended by Administrative Rules Supplement 2020-379, January 2021, effective 1/1/2021.General Authority: NDCC 64-02-03
Law Implemented: NDCC 64-02-02