Statutes, codes, and regulations
New York Codes, Rules and Regulations
Title 17 - DEPARTMENT OF TRANSPORTATIONChapter V - New York State Supplement To The National Manual On Uniform Traffic Control Devices For Streets And Highways-2009 EditionPart 3 - Markings
Chapter 3B - Pavement And Curb Markings
Section 3B.02 - No-Passing Zone Pavement Markings and Warrants

N.Y. Comp. Codes R. & Regs. tit. 17 § 3B.02

Download
PDF
Current through Register Vol. 46, No. 45, November 2, 2024
Section 3B.02 - No-Passing Zone Pavement Markings and Warrants

DELETE Paragraph 07.

INSERT the following paragraphs:

Support:

00A An order, ordinance, rule, or regulation pertaining to the application of pavement markings in accordance with this manual is necessary for no-passing zones to be "official markings," as referred to in Section 1126(a) of the New York State Vehicle and Traffic Law.

Standard:

06A Yellow one-way or two way no-passing zone markings, as appropriate, shall connect no-passing zones when there is insufficient length for unrestricted passing, (i.e. less than 400 feet between successive no-passing zones).

Standard:

06B A no-passing zone for traffic in a particular direction shall be at least 400 feet in length. Where the actual no-passing distance is less than 400 feet, the additional length of yellow no-passing zone markings shall be added at the beginning of the zone.

Support:

06C It is generally unnecessary to mark no-passing zones on two-lane, two-way urban highways. Speeds are generally low and, where markings are provided, the yellow broken centerline marking is usually sufficient.

Standard:

06D Where used, the minimum length of a no-passing zone on two-lane, two-way urban highways shall be 200 feet.

N.Y. Comp. Codes R. & Regs. Tit. 17 § 3B.02