N.Y. Comp. Codes R. & Regs. Tit. 12 §§ 14-9.45

Current through Register Vol. 46, No. 53, December 31, 2024

Section 14-9.45 - Stamping required for installation

(a) No boiler shall hereafter be installed in this State unless it has been constructed in accordance with the requirements of the American Society of Mechanical Engineers and the National Board of Boiler and Pressure Vessel Inspectors and is so stamped and registered.

(b) A hydrostatic pressure test shall be made after installation. If deemed advisable by the inspector, this test need not be made on boilers which are shipped as complete units.

(c) Hobby boilers and locomotive boilers are not acceptable for use where same have not been built as set forth herein, but may, however, be used if a Certificate of Inspection had been previously issued within the State.

N.Y. Comp. Codes R. & Regs. Tit. 12 §§ 14-9.45