N.J. Admin. Code § 19:6-2.11

Current through Register Vol. 56, No. 21, November 4, 2024

Section 19:6-2.11 - Boring methods

(a) Borings shall be made by the continuous driving and clearing out of a pipe casing (including telescoping of smaller sizes inside of larger casing) except as permitted in this subsection. Where casing is used, it shall be cleaned out to undisturbed soil prior to sampling and the sample spoon driven into soil that has not been affected by chopping, washing or hydrostatic imbalance.

1. Uncased borings: Uncased borings, including borings where the casing is omitted for part of the depth, may be used if the mud slurry method is followed. The requirements for soil sampling and rock coring shall be the same for uncased borings as for borings made using casing, except that prior to each soil sampling operation the boring shall be substantially cleaned of disturbed material and the sample spoon shall be advanced through any settled solids before counting the blows required to drive the spoon. Longer sample spoons, having a sludge chamber, shall be used where settled solids exceed six inches. In determining ground water levels, methods shall be used to reduce and replace the mud slurry so that the hydrostatic head may be measured. The procedures shall be described in detail in the records.

2. Auger borings: Borings may be made with augers except that short flight augers shall not be used in granular soils below the water level. Sampling procedures in auger borings for both soil and rock shall be the same as for cased borings. Full hydrostatic head shall be maintained in granular soils below the ground water level during the boring operation.

3. Maximum diameter: Where the bore hole, as drilled by any method, is in excess of four inches in diameter, sampling operations shall be performed through a temporary casing having a four-inch inside diameter or less.

N.J. Admin. Code § 19:6-2.11