N.J. Admin. Code § 19:5-8.1

Current through Register Vol. 56, No. 12, June 17, 2024

Section 19:5-8.1 - Final improvement plans

(a) Upon the approval of a preliminary plat, the applicant shall submit engineering drawings for the improvements required in 19:5-8.2, in accordance with the following:

1. Such drawings shall be submitted in triplicate to the NJMC a minimum of 60 days prior to the date of the submission of the application for final plat approval.

2. Such drawings shall be prepared, signed, and sealed by a New Jersey-licensed professional engineer.

3. Such drawings shall contain the following:

i. Plans, design details, specifications and cost estimates for street construction, including a center line profile and a grade line for each street with a typical cross-section of the roadway. The profiles of grade lines shall be shown at a scale of one inch equal to 100 feet horizontal, and one inch equal to 10 feet vertical. This information shall be shown on standard plan and profile sheets;

ii. Plans, design details, specifications, calculations, and cost estimates of proposed stormwater management facility improvements;

iii. Plans, design details, specifications and cost estimates of proposed water supply and distribution systems;

iv. Plans, design details, specifications and cost estimates of sanitary sewerage systems, including treatment plants;

v. Grading plans, lighting plans, street plantings and monument locations; and

vi. Such other information as may be required by the NJMC deemed necessary for the review of the improvements.

(b) The NJMC shall review all engineering drawings in order to determine whether such drawings are consistent with the approved preliminary plat and comply with the design standards of N.J.A.C. 19:5-7.

(c) In the event that the engineering drawings are not consistent with the approved preliminary plat or do not comply with the design standards of N.J.A.C. 19:5-7, the Chief Engineer shall notify the applicant in writing of the reasons why such drawings are inconsistent or do not comply. The applicant shall then correct such drawings.

(d) The Chief Engineer shall act upon the engineering drawings submitted to the NJMC at the same time or prior to the time that the Chief Engineer acts upon the final plat.

N.J. Admin. Code § 19:5-8.1