Section R. 408.31138 - Suspension and revocationRule 1138.
(1) The bureau may suspend or revoke the certification of a premanufactured unit or building component which the bureau finds not to comply with the act or these rules, or which has been manufactured pursuant to a building system or a compliance assurance program as to which approval has been suspended or revoked, or which has not been manufactured in accordance with the approved compliance assurance program. The bureau shall remove or cause to be removed, labels from a premanufactured unit or building component until it is brought into compliance with the act and these rules. Notice of suspension or revocation of certification shall be in writing with the reasons for suspension or revocation clearly set forth therein. Appeals from suspensions or revocations shall receive timely review.
(2) Upon suspension or revocation by the bureau or the commission of the approval of a building system or compliance assurance program, further labels shall not be attached to a premanufactured unit or building component manufactured pursuant to the building system or compliance assurance program with respect to which the approval was suspended or revoked. Upon termination of the suspension or revocation, labels may again be attached to the premanufactured unit or building component, manufactured after the date approval is reinstated. If any unit or building component has been manufactured during the period of suspension or revocation, it shall not be labeled unless the bureau, evaluation agency, or inspection agency has inspected the unit or building component and the bureau or an authorized inspection agency is satisfied that all requirements for certification have been met.(3) The manufacturer shall return all labels allocated for a premanufactured unit or building component to the bureau no later than 10 days from the effective date of the bureau's or the commission's suspension or revocation of the approval of the building system or compliance assurance program pursuant to which the premanufactured unit or building component is being manufactured. The manufacturer shall also return to the bureau all labels which it determines for any reason are no longer needed.Mich. Admin. Code R. 408.31138