Section R. 408.31136 - Manufacturer's data plateRule 1136.
(1) The following information shall be placed directly on 1 or more permanent manufacturer's data plates in the vicinity of the electrical distribution panel or in some other designated location acceptable to the commission, on the premanufactured unit or building component where it will be readily accessible for inspection:(a) Manufacturer's name and address.(b) Serial number of the unit.(d) Name and date of applicable nationally recognized codes complied with.(e) Model designation and name of manufacturer of major factory installed appliances.(f) Identification of permissible type of gas for appliances and directions for water and drain connection.(g) Snow, wind, seismic and other live loads.(h) Electrical ratings and instructions and warnings on voltage.(i) Special conditions or limitations on use of the unit, including unsuitability for areas in which specified environmental conditions prevail.(2) If, in the opinion of the bureau, the shape or size of a building component is such that the information required in subrule (1) cannot be attached to a component permanently, the information may be placed in a manual crated with the component or on a tag attached to the crate in which the component is shipped, if the information is not such that the future occupant of the building should know it. If the occupant will need to know the information, it shall be contained in a manual which shall be presented to the occupant upon transfer of possession. If life safety is involved, the item in question shall be plainly labeled.Mich. Admin. Code R. 408.31136