Md. Code Regs. 11.14.02.16
Current through Register Vol. 51, No. 12, June 14, 2024
| Procedures: | Reject Vehicle If: |
| (1) Open hood and inspect safety catch for proper operation. Close hood and inspect for proper full closure. Manually inspect latch or remote control for proper operation. (If engine is rear mounted, make a similar inspection of engine compartment and hood door.) Stud and safety pin-type latch is acceptable provided pressure is necessary to remove the pin from the stud. | (1) Hood does not cover at least the top of the engine compartment. (Full hood is required on school vehicles). |
| (2) Inspect for height of air scoop or bubble. | (2) Air scoop or bubble higher than 1/3 the vertical height of the windshield. |
| (3) On vehicles where the engine extends inside the vehicle the interior engine cover shall be inspected for proper sealing. | (3) Hood latch and keeper not original equipment or equivalent. |
| (4) Hood is not equipped with a proper operating safety latch. | |
| (5) Latch and release mechanism of hood or engine cover is broken, missing, or improperly adjusted preventing the hood from being properly opened and closed. | |
| (6) Interior engine cover is not properly sealed to prevent the entrance of engine fumes or exhaust gases into the vehicle. |
Figure 27 HOOD SCOOP HEIGHT.
Md. Code Regs. 11.14.02.16