La. Admin. Code tit. 33 § V-3315

Current through Register Vol. 50, No. 6, June 20, 2024

Section V-3315 - General Groundwater Monitoring Requirements

The owner or operator must comply with the following requirements for any groundwater monitoring program developed to satisfy LAC 33:V.3317, 3319, or 3321.

A. The groundwater monitoring system must consist of a sufficient number of wells, installed at appropriate locations and depths, to yield groundwater samples from the uppermost aquifer that fulfill the following requirements.

1. The samples must represent the quality of background groundwater that has not been affected by leakage from a regulated unit. A determination of background groundwater quality may include sampling of wells that are not hydraulically upgradient of the waste management area where:

a. hydrogeologic conditions do not allow the owner or operator to determine which wells are hydraulically upgradient; and

b. sampling at other wells will provide an indication of background groundwater quality that is representative or more representative than that provided by the upgradient wells.

2. The samples must represent the quality of water passing the point of compliance.

3. The samples must allow for the detection (as defined in LAC 33:V.3303.A.1) of contamination when hazardous waste or hazardous constituents have migrated from the waste management area to the uppermost aquifer.

B. If a facility contains more than one regulated unit, separate groundwater monitoring systems are not required for each regulated unit, if provisions for sampling the groundwater in the uppermost aquifer will enable detection and measurement at the compliance point for hazardous constituents for the regulated units.

C. All monitoring wells must be cased in a manner that maintains the integrity of the monitoring-well bore hole. This casing must be screened or perforated, and packed with gravel or sand, where necessary, to enable collection of groundwater samples. The annular space (i.e., the space between the bore hole and well casing) above the sampling depth must be sealed to prevent contamination of samples and the groundwater.

D. The groundwater monitoring program must include consistent sampling and analysis procedures that are designed to ensure monitoring results that provide a reliable indication of groundwater quality below the waste management area. At a minimum, the program must include procedures and techniques for:

1. sample collection;

2. sample preservation and shipment;

3. analytical procedures; and

4. chain of custody control.

E. The groundwater monitoring program must include sampling and analytical methods that are appropriate for groundwater sampling, and that accurately measure hazardous constituents in groundwater samples.

F. The groundwater monitoring program must include a determination of the groundwater surface elevation each time groundwater is sampled.

G. In detection monitoring or where appropriate in compliance monitoring, data on each indicator parameter and on each hazardous constituent specified in the permit will be collected from background wells and wells at the compliance point(s). The number and kinds of samples collected to establish background shall be appropriate for the form of statistical test employed, following generally accepted statistical principles. The sample size shall be as large as necessary to ensure with reasonable confidence that a contaminant release to groundwater from a facility will be detected. The owner or operator will determine an appropriate sampling procedure and interval for each hazardous constituent listed in the facility permit which shall be specified in the unit permit upon approval by the administrative authority. This sampling procedure shall be:

1. a sequence of at least four samples, taken at an interval that assures, to the greatest extent technically feasible, that an independent sample is obtained, by reference to the uppermost aquifer's effective porosity, hydraulic conductivity, and hydraulic gradient, and the fate and transport characteristics of the potential contaminants; or

2. an alternate sampling procedure proposed by the owner or operator and approved by the administrative authority.

H. The owner or operator will specify one of the following statistical methods to be used in evaluating groundwater monitoring data for each indicator parameter and hazardous constituent that, upon approval by the administrative authority, will be specified in the unit permit. The statistical test chosen shall be conducted separately for each indicator parameter and hazardous constituent in each well. Where practical quantification limits (PQLs) are used in any of the following statistical procedures to comply with LAC 33:V.3315.I.5, the PQL must be proposed by the owner or operator and approved by the administrative authority. Use of any of the following statistical methods must be protective of human health and the environment and must comply with the performance standards outlined in LAC 33:V.3315.I.

1. A parametric analysis of variance (ANOVA) followed by multiple comparisons procedures to identify statistically significant evidence of contamination. The method must include estimation and testing of the contrasts between each compliance well's mean and the background mean levels for each constituent.

2. An analysis of variance (ANOVA) based on ranks followed by multiple comparisons procedures to identify statistically significant evidence of contamination. The method must include estimation and testing of the contrasts between each compliance well's median and the background median levels for each constituent.

3. A tolerance or prediction interval procedure in which an interval for each constituent is established from the distribution of the background data, and the level of each constituent in each compliance well is compared to the upper tolerance or prediction limit.

4. A control chart approach that gives control limits for each constituent.

5. Another statistical test method submitted by the owner or operator and approved by the administrative authority.

I. Any statistical method chosen under LAC 33:V.3315.H for specification in the unit permit shall comply with the following performance standards, as appropriate.

1. The statistical method used to evaluate groundwater monitoring data shall be appropriate for the distribution of chemical parameters or hazardous constituents. If the distribution of the chemical parameters or hazardous constituents is shown by the owner or operator to be inappropriate for a normal theory test, then the data should be transformed or a distribution-free theory test should be used. If the distributions for the constituents differ, more than one statistical method may be needed.

2. If an individual well comparison procedure is used to compare an individual compliance well constituent concentration with background constituent concentrations or a groundwater protection standard, the test shall be done at a Type I error level no less than 0.01 for each testing period. If a multiple comparisons procedure is used, the Type I experimentwise error rate for each testing period shall be no less than 0.05; however, the Type I error of no less than 0.01 for individual well comparisons must be maintained. This performance standard does not apply to tolerance intervals, prediction intervals, or control charts.

3. If a control chart approach is used to evaluate groundwater monitoring data, the specific type of control chart and its associated parameter values shall be proposed by the owner or operator and approved by the administrative authority if he or she finds it to be protective of human health and the environment.

4. If a tolerance interval or a prediction interval is used to evaluate groundwater monitoring data, the levels of confidence and, for tolerance intervals, the percentage of the population that the interval must contain, shall be proposed by the owner or operator and approved by the administrative authority if he or she finds these parameters to be protective of human health and the environment. These parameters will be determined after considering the number of samples in the background data base, the data distribution, and the range of the concentration values for each constituent of concern.

5. The statistical method shall account for data below the limit of detection with one or more statistical procedures that are protective of human health and the environment. Any practical quantification limit (PQL) approved by the administrative authority under LAC 33:V.3315.H that is used in the statistical method shall be the lowest concentration level that can be reliably achieved within specified limits of precision and accuracy during routine laboratory operating conditions that are available to the facility.

6. If necessary, the statistical method shall include procedures to control or correct for seasonal and spatial variability as well as temporal correlation in the data.

J. Groundwater monitoring data collected in accordance with LAC 33:V.3315.G including actual levels of constituents must be maintained in the facility operating record. The administrative authority will specify in the permit when the data must be submitted for review.

K. The groundwater monitoring program must ensure that the permittee maintains records from all required groundwater monitoring wells and associated groundwater surface elevations for the active life of the facility, including the operating, closure, and post-closure care periods.

La. Admin. Code tit. 33, § V-3315

Promulgated by the Department of Environmental Quality, Office of Solid and Hazardous Waste, Hazardous Waste Division, LR 10:200 (March 1984), amended LR 10:496 (July 1984), LR 16:614 (July 1990), amended by the Office of the Secretary, Legal Affairs Division LR 34:630 (April 2008).

AUTHORITY NOTE: Promulgated in accordance with R.S. 30:2180 et seq.