Current through Register Vol. 43, No. 45, November 7, 2024
Section 28-19-31 - Emission limitationsSubject to the provisions of regulations 28-19-9 and 28-19-11:
(a) A person shall not cause or permit the emission of particulate matter exceeding the specifications in table H-1 of this regulation. TABLE H-1 Emission Limits for Indirect Heating Equipment
For Table see Agency.
(b) A person shall not cause or permit visible contaminant emissions from any indirect heating equipment which equals or exceeds the following opacities: (1) Existing equipment: 40 percent opacity; (2) New equipment: 20 percent opacity. (c) A person responsible for operation of any indirect heating equipment having a heat input of 250 million BTU/hr or greater shall not cause or permit the emission of more than 3.0 pounds of sulfur dioxide per million BTU of heat input unless an alternative sulfur dioxide emission limit applicable to such indirect heating equipment is specified in a permit issued pursuant to K.A.R. 28-19-14. The operation of any indirect heating equipment for which an alternative sulfur dioxide emission limit has been specified by permit pursuant to this subsection shall be in compliance with such alternative sulfur dioxide emission limit on and after the effective date of the permit limitation in lieu of the 3.0 pounds of sulfur dioxide per million BTU of heat input limit specified in this subsection. Any alternative sulfur dioxide emission limit specified in a permit must be adequate to protect the ambient air quality standards for sulfur dioxide, and shall not be deemed an applicable implementation plan requirement under the federal clean air act until approved pursuant to section 110 of the act (42 U.S.C. §7410). (d) A person responsible for operation of any gas or oil-fired indirect heating equipment having a heat input of 250 million BTU/hr or greater shall not cause or permit the emission of more than 0.30 pounds of nitrogen oxides per million BTU of heat input per hour. (e) A person responsible for operation of any coal fired indirect heating equipment having a heat input of 250 million BTU/hr or greater shall not cause or permit the emission of more than 0.90 pounds of nitrogen oxides (calculated as NO2) per million BTU of heat input per hour. Kan. Admin. Regs. § 28-19-31
Authorized by and implementing K.S.A. 65-3005, 65-3010; effective Jan. 1, 1971; amended Jan. 1, 1972; amended, E-73-8, Dec. 27, 1972; amended Jan. 1, 1974; amended May 1, 1986; amended Nov. 8, 1993.