864 Ind. Admin. Code 1.1-7-2

Current through October 31, 2024
Section 864 IAC 1.1-7-2 - Design and contents of seal

Authority: IC 25-31-1-7; IC 25-31-1-8

Affected: IC 25-31-1-16

Sec. 2.

(a) The engineer seal shall generally be between one and five-eighths (1 5/8) inches and one and seven-eighths (1 7/8) inches in outside diameter, using the following

Click here to view Image

Plans containing an engineer seal of specified size may be reduced as long as the seal remains legible.

(b) The seal may be embossed, electronically applied to a drawing, or applied by a rubber stamp in conformance with the design as shown in subsection (a). The seal may have a milled edge, as shown, or two (2) concentric circles with the outer and inner circles corresponding with the respective edges of the milling.
(c) The name and registration number of the registrant inscribed on the seal shall correspond to the name and certificate number inscribed on the certificate of registration. However, the letters "PE" may be excluded from the certificate number.

864 IAC 1.1-7-2

State Board of Registration for Professional Engineers; Rule 7, Sec 2; filed Feb 29, 1980, 3:40 p.m.: 3 IR 632; filed Oct 17, 1986, 2:20 p.m.: 10 IR 441; filed Sep 24, 1992, 9:00 a.m.: 16 IR 729; filed Mar 28, 1995, 2:00 p.m.: 18 IR 2109; readopted filed Jun 21, 2001, 9:01 a.m.: 24 IR 3824; readopted filed Jul 19, 2007, 12:56 p.m.: 20070808-IR-864070063RFA
Readopted filed 11/22/2016, 12:27 p.m.: 20161221-IR-864160321RFA
Readopted filed 7/20/2022, 8:12 a.m.: 20220817-IR-864220189RFA
Readopted filed 5/30/2024, 9:44 a.m.: 20240626-IR-864230822RFA