Ill. Admin. Code tit. 35 § 223.120

Current through Register Vol. 48, No. 49, December 6, 2024

Section 223.120 - Incorporations by Reference

The following materials are incorporated by reference. These incorporations do not include any later amendments or editions.

a)40 CFR 59, subpart D, appendix A, Determination of Volatile Matter Content of Methacrylate Multicomponent Coatings Used as Traffic Marking Coatings, 64 Fed. Reg. 35002 (June 30, 1999).

b)40 CFR 59, subpart C, National Volatile Organic Compound Emission Standards for Consumer Products, 69 Fed. Reg. 18803 (April 4, 2004).

c)40 CFR 60, appendix A, Method 24, Determination of Volatile Matter Content, Water Content, Density, Volume Solids, and Weight Solids of Surface Coatings, 36 Fed. Reg. 24877 (December 23, 1971).

d)40 CFR 82, subpart A, appendix A, Class I Controlled Substances, 68 Fed. Reg. 42892 (July 18, 2003) and appendix B, Class II Controlled Substances, 68 Fed. Reg. 2859 (January 21, 2003).

e)29 CFR 1910.1200(d)(4), Hazard Communication, 61 Fed. Reg. 9245 (March 7, 1996).

f) ASTM International, 100 Barr Harbor Drive, PO Box C700, West Conshohocken PA 19428-2959.

1) ASTM E119-05a, Standard Test Methods for Fire Tests of Building Construction and Materials, approved November 1, 2005.

2) ASTM D523-89 (1999), Standard Test Method for Specular Gloss, approved May 10, 1999.

3) ASTM D1640-03, Standard Test Methods for Drying, Curing, or Film Formation of Organic Coatings at Room Temperature, approved December 1, 2003.

4) ASTM D3912-95 (2001), Test Method for Chemical Resistance of Coating Used in Light-Water Nuclear Power Plants, reapproved 2001.

5) ASTM D4082-02, Test Method for Effects of Radiation on Coatings Used in Light-Water Nuclear Power Plants, approved 2002.

6) ASTM D4214-98, Standard Test Methods for Evaluating the Degree of Chalking of Exterior Paint Films, approved August 10, 1998.

7) ASTM D1613-03, Standard Test Method for Acidity in Volatile Solvents and Chemical Intermediates Used in Paint, Varnish, Lacquer, and Related Products, approved October 1, 2003.

8) ASTM E84-07, Standard Test Method for Surface Burning Characteristics of Building Materials, approved 2007.

9) ASTM D4359-90 (2006), Standard Test Method for Determining Whether a Material is a Liquid or a Solid, reapproved 2006.

10) ASTM E260-96 (2006), Standard Practice for Packed Column Gas Chromatography, reapproved 2006.

11) ASTM E2167-01, Standard Guide for Selection and Use of Stone Consolidants (see section 4, Stone Consolidant), approved 2001.

12) ASTM C836-06, Specification for High Solids Content, Cold Liquid-Applied Elastomeric Waterproofing Membrane for Use with Separate Wearing Course, approved 2006.

13) ASTM D86-07b, Standard Test Method for Distillation of Petroleum Products at Atmospheric Pressure, approved 2007.

g) South Coast Air Quality Management District, 21865 Copley Dr., Diamond Bar CA 91765.

1) South Coast Air Quality Management District (SCAQMD) Method 304-91, Determination of Volatile Organic Compounds in Various Materials, revised February 1996.

2) SCAQMD Method 303-91, Determination of Exempt Compounds, revised February 1993.

3) SCAQMD Method 318-95, Determination of Weight Percent Elemental Metal in Coatings by X-Ray Diffraction, approved July 1996.

4) SCAQMD Rule 1174, Ignition Method Compliance Certification Protocol (adopted October 5, 1990).

h) Bay Area Air Quality Management District Office, 939 Ellis Street, San Francisco CA 94109.

1) Bay Area Air Quality Management District (BAAQMD) Method 43, Determination of Volatile Methylsiloxanes in Solvent-Based Coatings, Inks, and Related Materials, proposed amendment February 4, 2004.

2) BAAQMD Method 41, Determination of Volatile Organic Compounds in Solvent-Based Coatings and Related Materials Containing Parachlorobenzotrifluoride, proposed amendment February 4, 2004.

i) California Air Resources Board (CARB) Method 310, Determination of Volatile Organic Compounds in Consumer Products and Reactive Organic Compounds in Aerosol Coating Products, amended May 5, 2005. California Air Resources Board, 1001 I Street, PO Box 2815, Sacramento CA 95812.

j) California Code of Regulations (CCR), title 17 § 94509(h), Standards for Consumer Products (2005).

k) California Code, Health and Safety Code, § 41712(h)(2) (2005).

l) 17 CCR Article 4, Alternate Control Plan §§ 94540-94555 (1996).

m) 17 CCR § 94511, Innovative Products (1997).

n) 17 CCR § 94503.5, Innovative Products (1996).

o)7 USC 136 to 136 y, FIFRA, Environmental Pesticide Control, published January 19, 2004, in Supplement III of the 2000 Edition of the United States Code.

p) Federal Specification MMM-A-181D, Adhesives, Phenol, Resorcinol, or Melamine Base (1980).

Ill. Admin. Code tit. 35, § 223.120