Ill. Admin. Code tit. 35 § 215.447

Current through Register Vol. 48, No. 49, December 6, 2024

Section 215.447 - Monitoring Program for Leaks

a) The owner or operator of a petroleum refinery subject to Section 215.445 shall, for the purpose of detecting leaks, conduct a component monitoring program consistent with the following provisions:

1) Test all pressure relief valves in gaseous service, pump seals, pipeline valves, process drains and compressor seals by methods and procedures approved by the Agency not earlier than March 1 or later than June 1 of each year;

2) Again test all pressure relief valves in gaseous service, pipeline valves in gaseous service and compressor seals by methods and procedures approved by the Agency not earlier than June 1 or later than August 1 of each year;

3) Observe visually all pump seals weekly;

4) Test immediately any pump seal from which liquids are observed dripping;

5) Test any relief valve within 24 hours after it has vented to the atmosphere; and

6) Test immediately after repair any component that was found leaking.

b) Inaccessible valves, storage tank valves and pressure relief devices connected to an operating flare header or vapor recovery device are exempt from the monitoring requirements in Subsection (a).

c) The Agency may require more frequent monitoring than would otherwise be required by Subsection (a) for components which are demonstrated to have a history of leaking.

Ill. Admin. Code tit. 35, § 215.447

Amended at 7 Ill. Reg. 1244, effective January 21, 1983