Section 58.01.07.200 - RELEASE REPORTING01.Information to be Reported. In addition to the provisions in 40 CFR Part 280, Subpart E, and IDAPA 58.01.02, "Water Quality Standards," Sections 851 and 852, owners or operators must report to the Department, on forms provided by the Department, the following information regarding confirmed UST releases within ninety (90) days of a confirmed release: a. The release source; and02.Release Sources. Release sources may include, but are not limited to the following: c. Dispensers, which include the dispenser and equipment used to connect the dispenser to the piping. A release from a suction pump or components located above the shear valve would be an example of a release from the dispenser;d. Submersible turbine pump area, which includes the submersible turbine pump head (typically located in the tank sump), the line leak detector, and the piping that connects the submersible turbine pump to the UST; ande. Delivery problem, which identifies releases that occurred during product delivery to the UST. Typical causes associated with this source are spills and overfills.03.Release Causes. Release causes may include, but are not limited to the following: a. Spills which may occur when the delivery hose is disconnected from the fill pipe of the UST or when the nozzle is removed from the vehicle at the dispenser;b. Overfills which may occur from the fill pipe at the UST or when the nozzle fails to shut off at the dispenser;c. Physical or mechanical damage of all types except corrosion. Examples include a puncture of the UST or piping, loose fittings, broken components, and components that have changed dimension like elongation or swelling;d. Corrosion of a metal tank, piping, flex connector, or other component; ande. Installation problem that occurs specifically because the UST system was not installed properly.Idaho Admin. Code r. 58.01.07.200