Section 16.02.14.270 - WALL INLETS01.General Inlet Requirements. Except as otherwise provided in this rule, inlets must:a. Be rounded and smooth and installed not less than eighteen (18) inches below the normal operating level and located to produce a uniform circulation, without the existence of dead spots; andb. Not extend from the pool wall or floor so as to create a hazard.02.Wall Inlet Requirements. If wall inlets are used, there must:a. Be at a minimum of one (1) per each six hundred (600) square feet of pool surface area.b. Be a minimum of two (2) inlets. In case of a shallow pool, the Director's designee may grant an exception to this requirement if inlets cannot be installed at the depth otherwise required.Idaho Admin. Code r. 16.02.14.270