Subchapter 6 - MINIMUM SAFETY STANDARDS - DESIGN OF PIPELINE COMPONENTS
- Section 6-77-40 - Scope
- Section 6-77-41 - General requirements
- Section 6-77-42 - Qualifying metallic components
- Section 6-77-43 - Valves
- Section 6-77-44 - Flanges and flange accessories
- Section 6-77-45 - Standard fittings
- Section 6-77-46 - Tapping
- Section 6-77-47 - Components fabricated by welding
- Section 6-77-48 - Welded branch connections
- Section 6-77-49 - Extruded outlets
- Section 6-77-50 - Flexibility
- Section 6-77-51 - Supports and anchors
- Section 6-77-52 - Compressor stations: design and construction
- Section 6-77-53 - Compressor stations: liquid removal
- Section 6-77-54 - Compressor stations: emergency shutdown
- Section 6-77-55 - Compressor stations: pressure limiting devices
- Section 6-77-56 - Compressor stations: additional safety equipment
- Section 6-77-57 - Compressor stations: ventilation
- Section 6-77-58 - Pipe-type and bottle-type holders
- Section 6-77-59 - Additional provisions for bottle-type holders
- Section 6-77-60 - Transmission line valves
- Section 6-77-61 - Distribution line valves
- Section 6-77-62 - Vaults: structural design requirements
- Section 6-77-63 - Vaults: accessibility
- Section 6-77-64 - Vaults: sealing, venting, and ventilation
- Section 6-77-65 - Vaults: drainage and waterproofing
- Section 6-77-66 - Design pressure of plastic fittings
- Section 6-77-67 - Valve installation in plastic pipe
- Section 6-77-68 - Protection against accidental overpressuring
- Section 6-77-69 - Control of the pressure of gas delivered from high-pressure distribution systems
- Section 6-77-70 - Requirements for design of pressure relief and limiting devices
- Section 6-77-71 - Required capacity of pressure relieving and limiting stations
- Section 6-77-72 - Instrument, control, and sampling pipe and components