Section 11-264-1057 - Standards: Valves in gas/vapor service or in light liquid service(a) Each valve in gas/vapor or light liquid service shall be monitored monthly to detect leaks by the methods specified in subsection 11-264-1063(b) and shall comply with subsections (b) through (e) , except as provided in subsections (f), (g), and (h), and sections 11-264-1061 and 11-264-1062.(b) If an instrument reading of ten-thousand ppm or greater is measured, a leak is detected.(c)(1) Any valve for which a leak is not detected for two successive months may be monitored the first month of every succeeding quarter, beginning with the next quarter, until a leak is detected.(2) If a leak is detected, the valve shall be monitored monthly until a leak is not detected for two successive months,(d)(1) When a leak is detected, it shall be repaired as soon as practicable, but no later than fifteen calendar days after the leak is detected, except as provided in section 11-264-1059.(2) A first attempt at repair shall be made no later than five calendar days after each leak is detected.(e) First attempts at repair include, but are not limited to, the following best practices where practicable: (1) Tightening of bonnet bolts.(2) Replacement of bonnet bolts.(3) Tightening of packing gland nuts.(4) Injection of lubricant into lubricated packing.(f) Any valve that is designated, as described in paragraph 11-264-1064(g) (2), for no detectable emissions, as indicated by an instrument reading of less than five-hundred ppm above background, is exempt from the requirements of subsection (a) if the valve: (1) Has no external actuating mechanism in contact with the hazardous waste stream.(2) Is operated with emissions less than five-hundred ppm above background as determined by the method specified in subsection 11-264-1063(c).(3) Is tested for compliance with paragraph (f) (2) initially upon designation, annually, and at other times as requested by the director.(g) Any valve that is designated, as described in paragraph 11-264-1064(h) (1), as an unsafe-to-monitor valve is exempt from the requirements of subsection (a) if: (1) The owner or operator of the valve determines that the valve is unsafe to monitor because monitoring personnel would be exposed to an immediate danger as a consequence of complying with subsection (a).(2) The owner or operator of the valve adheres to a written plan that requires monitoring of the valve as frequently as practicable during safe-to-monitor times.(h) Any valve that is designated, as described in paragraph 11-264-1064(h) (2), as a difficult-to-monitor valve is exempt from the requirements of subsection (a) if: (1) The owner or operator of the valve determines that the valve cannot be monitored without elevating the monitoring personnel more than two meters above a support surface.(2) The hazardous waste management unit within which the valve is located was in operation before June 21, 1990.(3) The owner or operator of the valve follows a written plan that requires monitoring of the valve at least once per calendar year.Haw. Code R. § 11-264-1057
[Eff 6/18/94; comp] (Auth: HRS §§ 342J-4, 342J-31, 342J-34, 342J-35) (Imp: 40 C.F.R. §264.1057 )